Photo 7 | Adjusting the |
| running belt |
Belt adjustment bolt
Take the following steps to adjust the running belt on the M9.4 treadmill (see Photo 7 for clarification). To ensure proper safety while adjusting your treadmill, all adjustments must be made while the treadmill is turned OFF.
1.Make sure that the treadmill is OFF and that the running belt is completely stopped.
2.Locate the belt adjustment bolt at the rear of the treadmill (see Photo 7). The direction you turn the bolt depends on how the belt is tracking. Make all belt adjustments on the left rear corner bolt using the hex key provided.
•If the belt tracks off center to the left, turn the adjusting bolt 1/4 turn clockwise, which moves the running belt to the right.
•If the belt tracks off center to the right, turn the adjusting bolt 1/4 turn counterclockwise; this moves the belt to the left.
Important: Do not turn the adjusting bolt more than 1/4 turn at a time.
Overtightening the bolt can damage the treadmill.
3.Turn ON the treadmill, then increase the speed of the running belt to 6 miles per hour. (You can follow Steps 1 through 3 of the procedure, Check- ing the Alignment of the Running Belt, if you need instructions about how to increase speed and check alignment.)
4.Observe the running belt for 30 seconds or more. The belt should track centered on the running bed.
5.Press the STOP keypad to stop the running belt.
6.If the belt needs additional alignment, repeat Steps 1 through 5 of this procedure until the belt is properly aligned.
page 20