Photo 3 | Installing lift | |
| motor | |
| Lift motor |
|
|
| |
Lift motor support mount
7. Slide the lift motor into position, shaft side down, with the long tube toward the front of the treadmill and the short tube facing the treadmill motor. (See Photo 3.)
8. Secure the lift motor by placing one of the two
| the 5/16" hex wrench (both are found in the hardware kit). Insert the bolt | ||
| through the lift motor mount and into the lift motor. Follow the same proce- | ||
| dure for the second shoulder bolt. (See Photo 3.) Align the motor and | ||
| securely tighten the shoulder bolts. | ||
| 9. Locate the two plastic plug caps in the hardware kit. Insert the plastic plug | ||
| caps over the two shoulder bolts on the lift motor support mount. | ||
|
|
|
|
Photo 4 | Plug |
| |
| |||
| wiring harness |
| |
| into printed circuit |
| |
| board |
| |
| Printed circuit |
| |
| board |
| |
| Lift motor wiring |
|
|
|
|
| |
| harness |
| |
| Lower board |
|
|
|
|
| |
| chassis |
| |
|
|
|
|
| 10. Plug the | ||
| board. (See Photo 4.) | ||
| 11. Using the cable ties supplied in the hardware kit, secure the | ||
| wiring to the lower board chassis. Cut the ends of the cable ties so the | ||
| excess plastic does not interfere with the motor or circuit board. | ||
page 9