Setting Up the M9.4 Electronic Treadmill, Ergometer

2	Setting Up the M9.4 Electronic Treadmill
	Ergometer
	You do not need any special knowledge or experience to set up an M9.4
	Electronic Treadmill Ergometer. However, you must carefully review and follow

the instructions in this manual. If you do not assemble and use this treadmill according to the following guidelines, you could void the Precor warranty.

Installation Requirements

Follow these installation requirements when installing the treadmill:

• Set up the M9.4 treadmill on a solid flat surface. Do not install the treadmill on deeply padded, plush, or shag carpeting due to possible damage to the carpet and machine. If the treadmill is placed on a carpeted surface, place a piece of heavy cardboard, plywood, or other smooth, flat surface under the unit to protect the carpet and treadmill.

• Locate the treadmill at least 4 feet from walls and furniture. Be sure to provide ample space in front of the machine to allow easy access to the ON/OFF power switch. Open space to the sides and back of the machine makes for a safer mount and dismount and easier belt adjustment.

• Use a standard 120-volt household outlet. Precor recommends that you plug the treadmill into an outlet with a dedicated 20 amp circuit breaker. The treadmill comes with a 20 amp circuit breaker to protect the electrical and electronic components from sustained overloads, and an integral 3-prong plug grounded for your safety and to protect the machine.

CAUTION: Do not remove or otherwise bypass the plug with an adapter in order to use a non-grounded outlet.

Assembly Instructions

Follow these instructions to assemble the M9.4 treadmill:

1.Make sure that the treadmill is unplugged and turned OFF. Do not assemble the M9.4 treadmill if it is plugged in and turned ON.

2.Remove the black hood by unscrewing the eight phillips-head screws.

page 7