Photo 1 | Handrail/display |
| assembly |
Handrail/display assembly
Running bed
Handrail/display assembly mounts
| 3. | Remove the four 5/16" locknuts and washers (two on each side) from the | |
|
| handrail/display assembly mounts near the front of the running bed as | |
|
| shown in Photo 1. | |
| 4. | Position the handrail assembly so both the right and left handrail columns | |
|
| align over the mounts. Replace the washers and locknuts. Using the hex | |
|
| key provided in the hardware kit, securely tighten each locknut. | |
| 5. | Locate the ribbon cable connector that protrudes from the handrail/display | |
|
| assembly. | |
|
|
| |
Photo 2 | Installing ribbon |
| |
| |||
| cable connector | ||
Printed circuit board
Ribbon cable receptacle
Ribbon cable connector
Handrail/display assembly
6.Align the tab on the side of the ribbon cable connector with its correspond- ing receptacle on the printed circuit board located near the motor. (See Photo 2.) Make sure that all pins are aligned and fully engaged. The connector is designed to engage in one direction only. Do not force the connector into the receptacle.
page 8