Precor EFX 821 manual Informational Displays Prior to Shutdown, Symptoms of a Low Battery

Page 34

32

Assembling and Maintaining the EFX 821 Elliptical Fitness Crosstrainer

Informational Displays Prior to Shutdown

The equipment saves its battery charge by moving into a shutdown mode. If the user does not maintain the minimum rate of motion, a 30-second shutdown process begins.

In this mode, the console displays a countdown indicator and ignores all keypresses. If no movement is detected or the rate of motion remains below the minimum, the indicator changes as the countdown continues.

Note: The user can resume exercising before the countdown period elapses and the program will continue from the point at which it was paused.

Important: If the equipment is connected to a CSAFE master device, it follows a slightly different shutdown process. Ten seconds before the equipment shuts down, it ends the exercise session and displays a reset message while it disconnects from the CSAFE master device. It ignores all keypresses during these last ten seconds.

Symptoms of a Low Battery

If no one has used the equipment for an extended period of time, the battery may need recharging.

Symptoms of a low battery include the following:

A flickering or erratic display

Loss of user and program information after the user stops exercising, without any display of a workout summary or a notification of pending shutdown

Important: To maintain a constant power source, use the optional power adapter.

Image 34
Contents Page Page Page Trademark Note Edition InformationIntellectual Property Notice Important Safety Instructions Safety PrecautionsPage  Do not lean on or pull on the console at any time Hazardous Materials and Proper Disposal Educating UsersProduct Recycling and Disposal Regulatory Notices for Cardiovascular Exercise Equipment Industry Canada 240 V Equipment Designated for U.S. MarketsEuropean Applications Obtaining Service Obtaining Updated DocumentationPage Table of Contents Page Assembling the EFX  Set up the unit on a solid, flat surface Installation Requirements Insert all fasteners with your fingers Required Tools Hardware Kit not to scaleFasteners To begin assembly Assembling the EFXInstalling the Display Console Mount Important Place excess cable inside the upright supportAttaching the side bolts Installing the Bottle Holder To install the bottle holderInstalling the Handlebars To install the moving handlebarsAttaching the movable arms Attaching the Caps and Upright Support Cover To attach the caps and upright support coversMaking Sure the Unit is Stable To level the unitVerifying that the Heart Rate Display is Operational Breaking in the EquipmentTo verify that the heart rate display is operational Page Installing the Console Threading the Cable Assembly To thread the cable assemblyConnecting Cables Completing the Console Installation To complete the installationSelf-Powered Features Minimum requirements for operation Equipment Rate of MotionSymptoms of a Low Battery Informational Displays Prior to ShutdownUsing the Optional Power Adapter Optional Power Adapter KitReplacing the Battery Maintenance Daily CleaningWeekly Maintenance Daily InspectionMonthly Maintenance Moving the Equipment Storing the Chest StrapLong-Term Storage Limited Warranty Commercial Cardiovascular Equipment Limited WarrantyWarranty Periods and Coverage Conditions and Restrictions Exclusive Remedies Exclusion of Consequential and Incidental Damages Complete this portion and keep for your recordsPage Page Page Precor Incorporated