Precor EFX 821 manual Installation Requirements,  Set up the unit on a solid, flat surface

14 Assembling and Maintaining the EFX 821 Elliptical Fitness Crosstrainer

Begin installation of all fasteners by hand, then partially tighten them. Do not fully tighten fasteners until instructed to do so.

Important: When wrench-tightening the screws, make sure the head of the fastener is parallel to the product surface. If it is not, stop tightening to avoid cross-threading. To avoid further damage, stop assembly work and contact Customer Support.

Installation Requirements

Follow these installation requirements when assembling the unit:

Assemble the unit near the location where you plan to use it.

Provide ample space around the unit.

Open space around the unit allows for easier access.

Set up the unit on a solid, flat surface.

A smooth, flat surface under the unit helps keep it level. A level unit has fewer malfunctions.

Open the box and assemble the components in the sequence presented in this guide.

The unit is shipped in one box. Ask for help from two or more people to unpack and assemble the Climber.

Insert all fasteners with your fingers.

Use your fingers to properly align and thread the fasteners. This helps alleviate cross-threading. Do not fully wrench tighten fasteners until instructed to do so.

Important: When wrench tightening, the head of the fastener should be flush with the product. If it is not, cross-threading may have occurred. Do not attempt to rework the assembly as more damage to the equipment will occur. Contact Customer Support. Refer to Obtaining Service.

If you plan to move the unit, obtain help and use a hand truck.

Do not grasp any plastic parts while lifting or moving the unit. The plastic parts are not capable of supporting the weight of the unit and they may break.