Precor P10 manual Regulatory Notices for Cardiovascular Exercise Equipment

Page 10

8

Operating and Maintaining the P10 Console

Regulatory Notices for Cardiovascular Exercise Equipment

The regulatory information in this section applies to the exercise equipment and its control console.

Safety Approvals for Cardiovascular Equipment

Precor equipment has been tested and found to comply with the following applicable safety standards.

Cardiovascular Type Equipment:

CAN/CSA, IEC, EN 60335-1 (Household and similar electrical appliances - Safety)

EN 957 (Stationary training equipment, class S/B compliant equipment)

Radio Frequency Interference (RFI)

This Precor exercise equipment conforms to the following national standards defining acceptable limits for radio frequency interference (RFI).

Federal Communications Commission, Part 15

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation. The equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the owner’s manual instructions, can cause harmful interference to radio communications.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING Per FCC rules, changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

Image 10
Contents Operating and Maintaining the P10 Console Page Page Trademark Note Edition InformationIntellectual Property Notice Important Safety Instructions Safety PrecautionsOperating and Maintaining the P10 Console Important Safety Instructions Operating and Maintaining the P10 Console Hazardous Materials and Proper Disposal Product Recycling and DisposalCardiovascular Type Equipment Safety Approvals for Cardiovascular EquipmentRegulatory Notices for Cardiovascular Exercise Equipment Radio Frequency Interference RFIEuropean Applications Industry CanadaDébranchez avant de réparer North American 120-volt, 20-amp power receptacle Electrical Recommendations 120 V and 240 V TreadmillsObtaining Service IEC-320 C13 and C14 plugsOperating and Maintaining the P10 Console Table of Contents Operating and Maintaining the P10 Console Activating the Console for Self-Powered Equipment Activating the Console for Self-Powered EquipmentGetting Started Optional Use of the Power Adapter Identifying Parts of the Console P10 console keys Parts of the console Number Name DetailsNumber Name Details Setting Up the Console System SettingsNavigational keys for the system setting modes Key Function Safety Code Treadmill onlyTo view the Club Settings Club ParametersSet Max Workout Time All Equipment Select Language All EquipmentSet Units All Equipment Set Max Pause Time All EquipmentSet Incline Limit Treadmill only Set Cool Down Time All EquipmentSet Speed Limit Treadmill only Hidden Programs Treadmill onlySet Crossramp Auto-level EFX only Remote Speed Control Treadmill onlySet Auto Stop Treadmill only Set Resistance Range Bike onlyTo view the System settings Viewing the Informational DisplaysProduct Value Information provided Hour MeterEvent Error Log Event Description of Event Number Csafe access keys Keys Function User ID Entry with Csafe EquipmentUsing the Touch Heart Rate Feature Introducing Users to the P10 ConsoleHeart rate target zones Using a Chest Strap Transmitter To use a chest strap transmitterUsing the Treadmill Safety Clip Restart switchAttaching the safety clip Treadmill Auto Stop Automatic Stop Function Starting a Workout  Press Quick StartPausing and Resuming an Exercise Session Starting a Preset Programmed WorkoutPaused Externally Powered Equipment Pending Shutdown Self-Powered Equipment Ending a Session Cleaning the Console and Display MaintenanceTo remove dust and dirt from the console Changing the Belt Newer Model AMT Only Page Precor Incorporated Assembling and Maintaining TRM 800-Series Treadmills Page Page Assembling and Maintaining TRM 800-SERIES Treadmills Important Safety Instructions Assembling and Maintaining TRM 800-Series Treadmills Important Safety Instructions 19.7 in. behind or in front the machine Safety Code Educating Users Regulatory Notices for the Rfid Module Radio Frequency Interference RFI PVS and P80 Regulatory Notice Federal Communications Commission, Part Industry Canada Treadmill Grounding Instructions Obtaining Service Obtaining Updated Documentation Checking Treadmill Alignment and Adjusting Commercial Cardiovascular Equipment Limited Warranty To prepare the treadmill for assembly Assembling the TreadmillInstallation Requirements Required ToolsHardware Kit not to scale FastenersUnpacking the Cables To unpack the cablesRemoval and replacement of the rear fairing cover To begin assembly of the frame Assembling the FrameUpright support attachment, right side Blank plate removal To thread cables through the frame Cable connections and mounting points in the treadmill baseCable connections and mounting points Component Appearance Already Lower InstalledPoint Upright support attachment, left side Completing Assembly To secure the fastenersChecking Treadmill Alignment and Adjusting the Running Belt To complete assembly of the treadmill baseLeveling the Unit To level the treadmillPlugging In the Power Cord Leveling foot adjustmentBreaking in the Equipment Installing the Console Threading the Cable Assembly P80 To thread the cable assemblyConsole positioning on base unit Connecting Cables P80 Cable connections, P80 consoleTo connect the television cable Connecting the Television CableP80 internal cable connections Cable Connector Type Circuit LocationConnecting the television cable Connecting the Ethernet and Base Unit Data Cables Connecting the Ethernet and base unit data cablesConnecting the Heart Rate Sensor Cable Connecting the heart rate cableConnecting the Power Cable Connecting the power cableThreading the Cable Assembly P30 and P10 Completing the Console Installation P80To complete the installation Cable positioning Connecting Cables P30 and P10 Cable routing from the mount into the consoleCable connections, P30 and P10 consoles Cable Connector Type Circuit Location Completing the Console Installation P30 and P10P30 and P10 internal cable connections Reassembling the Treadmill Fairing To reassemble the fairingVerifying That the Heart Rate Display Is Operational To verify that the heart rate display is operationalDaily Cleaning Daily Inspection Weekly Maintenance Monthly MaintenanceChecking the Alignment of the Running Belt To check the alignment of the running beltAdjusting the Running Belt To adjust the running beltStoring the Chest Strap Moving the Equipment To put the treadmill into an inclined position for movingLong-Term Storage Entering the Safety Code Treadmill Safety FeaturesTo enter the safety code and start the treadmill Using the Treadmill Safety Clip Weight Limit Turning the Treadmill On and OffLocation Limited Warranty Commercial Cardiovascular Equipment Limited WarrantyWarranty Periods and Coverage Conditions and Restrictions Exclusive Remedies Exclusion of Consequential and Incidental Damages Complete this portion and keep for your recordsPage TRM 800-Series PAG/OM 300713-401 rev J