Precor EFX534i t owner manual Hazardous Materials and Proper Disposal, Safety Approval

Page 3

C O M M E R C I A L P R O D U C T S D I V I S I O N

IMPORTANT SAFETY INSTRUCTIONS

Diagram 1 Avoid injury from the roller arm mechanism.

Ramp

Front cover

Handlebar

Lower pivot roller arm (handlebar linkage)

•Never place your hand(s) or feet in the path of the roller arm because injury may occur to you or damage may occur to the equipment. Refer to Diagram 1.

•Never operate the unit if it is damaged, if it is not working properly, if it has been dropped, or dropped in water. Return the unit to a service center for examination and repair.

•Keep the optional power adapter cord away from heated surfaces.

•Do not operate where aerosol (spray) products are being used or where oxygen is being administered.

•Do not use outdoors.

•Do not attempt to service the EFX yourself other than the assembly and maintenance instructions found in this manual. Refer to Obtaining Service.

HAZARDOUS MATERIALS AND PROPER DISPOSAL

The EFX534i has an internal battery which must be removed before the EFX is scrapped. The battery contains materials which are considered hazardous to the environment. Proper disposal of the battery is required by federal law.

To remove the battery from the EFX, take the following steps:

CAUTION: Unplug the power adapter and disconnect it from its receptacle at the rear of the EFX.

Tools required: Phillips-head screwdriver and hex wrench set.

1.Remove both the right and left rear covers from the EFX.

2.Remove the top rear cover.

3.Unplug the black and red battery wires from the circuit board.

4.Separate the circuit board from the battery by removing four screws.

5.The battery is held in place with a metal bracket. Lift the battery away from the bracket.

6.Dispose of the battery according to the federal Hazardous Waste Regulations.

SAFETY APPROVAL

When identified with the ETL-c logo, the EFX has been tested and conforms to the requirements of CAN/CSA-E-335-1/3-94, Safety of Household and Similar Electrical Appliances.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

page 3

Image 3

Contents M M E R C I a L P R O D U C T S D I V I S I O N Important Safety Instructions Safety Approval Diagram 1 Avoid injury from the roller arm mechanismHazardous Materials and Proper Disposal Table of Contents Changing the Display Features using the Select Key Interval ProgramBack cover European Applications RFI Radio Frequency InterferenceEuropean Applications User’s authority to operate the equipmentModel number EFX534i Unit number Serial number EFX SELF-POWERED FeaturesObtaining Service Diagram 2 EFX serial number locationEquipment and prevent injuries to yourself About this ManualAcquiring the Appropriate Tools Unpacking the EFXStandard Equipment Other EquipmentHardware kit Hardware KITSetting Up the EFX Installation RequirementsAssembly Instructions Diagram Base tube Diagram 7 Connect the cablesDiagram 8 Place the base on supportive blocks Bolts G and washers H Frame stabilizer Mounting bolts Diagram 11 TightenHandlebars Protrusions Bracket Tighten bolts securely Diagram 12 SecureM M E R C I a L O D U C T S V I S I O N M M E R C I a L O D U C T S V I S I O N M M E R C I a L O D U C T S V I S I O N Bracket cover Diagram 16 SecureFoot pedal Diagram 17 Level the unitRotate rear adjustment pads Diagram 18 Clean the rampRemoving the Locking PIN Diagram 19 Insert the front end capTesting the Heart Rate Display Diagram 21 Wearing the chest strapDampen with water Changing the Custom Settings Custom Settings ModeElectrical power must be supplied Display key functions within the Custom Settings ModeDetermining the Units of Measure Setting a Workout Time Limit Setting a Pause Time LimitReset, Enter, QuickStart Moves the blinking LED from field to field Using Csafe Standard EquipmentEnter Reset User ID Entry Program KeysCenter Display Features on the Display ConsoleDiagram 23 EFX Display Console SmartRate display EFX534i DisplayQuickStart User Setup PromptsSetup Prompts Description SelectPrecor banner Using Quickstarttm During the Setup PromptsWeight prompt Press Quickstart Following occursCenter Display Low Battery Smartrate DisplayInformational Displays Prior to Shutdown Keys on the Display Console Diagram 24 Display console keypadPrompts Default Value Default ValuesExercising on the EFX Heart Rate FeatureUtilizing the Smartrate Feature Weight Loss ZoneWorkout Tips Diagram 26 Using the EFX handlebars Using the HandlebarsUsing the Stationary Handrail Changing the Display Features Using the Select KEYCarefully step down from the EFX Quick Steps to Working OUTIs detected PAUSE, Cool Down and Exit FeaturesCooling Down After a Workout A program, This is what happensPause Mode, you Press Reset Displays the Workout Summary bannerCool down Mode Inserting the Locking PINInterval Program Manual Mode and the Quickstarttm KEYPrograms Hill Climb ProgramTo use the interval program, take the following steps Diagram 27 Target ZonesCross Training Program Weight Loss ProgramMaintenance Cleaning the EquipmentInspection Servicing the EFX and Long Term Storage Symptoms of a LOW BatteryUsing the Power Adapter Storing the Chest StrapPower Adapter Power Cord Replacing the BatteryM M E R C I a L P R O D U C T S D I V I S I O N Thank You and Welcome to Precor How many members do you have? Date of Purchase Purchased from Dealer nameProduct Serial Numbers Please indicate the type and number of products purchasedComplete this portion and keep for your records Limited WarrantyWarranty Periods and Coverage Conditions and RestrictionsEFX 534i Programs 5 Total EFX 534i Display Readouts Product Specifications Electronic Specifications