JVC RX-7030VBK, RX-8030VBK Adjusting Sound, Basic Setting Items Basic Procedure, Press Adjust

Adjusting Sound

You can make sound adjustment to your preference after completing basic setting.

Basic Setting Items Basic Procedure

On the following pages, you can adjust the items listed below:

•You can adjust only the items applicable to the current sound mode.

•If Analog Direct is in use, you cannot make any sound adjustments.

	Items	To do	See page
DIGITAL EQ		Adjust equalizer pattern.	32
SUBWFR LVL		Adjust the subwoofer output level.	32
FRONT L LVL		Adjust the left front speaker output
		level.	32
FRONT R LVL		Adjust the right front speaker output
		level.	32
CENTER LVL		Adjust the center speaker output
		level.	32
SURR L LVL		Adjust the left surround speaker
		output level.	32
SURR R LVL		Adjust the right surround speaker
		output level.	32
SBACK LVL		Adjust the surround back speaker
		output level.	32
EFFECT*1		Adjust the DAP effect level.	33
ROOMSIZE*1		Select the room size for your virtual
		listening room.	33
LIVENESS*1		Select the liveness level for your
		virtual listening room.	33
CTR TONE		Make the center tone soft or sharp.	33
PANORAMA*2		Add “wraparound” sound effect with
		side-wall image.	33
CNTR WIDTH*2		Adjust the center channel localization
		between the center speaker and the
		left/right front speakers.	33
DIMENSION*2		Adjust sound localization position.	33
CNTR GAIN*3		Adjust sound localization of the
		center channel.	33
Notes:
*1	Adjustable when the DAP mode is in use.
*2	Adjustable when Pro Logic II Music is in use.
*3	Adjustable when Neo:6 Music is in use.

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Ex. When adjusting the subwoofer level to “–3”.

1. Press ADJUST.

The last selected item appears on the display.

	ANALOG
L	R	LINEAR PCM
SUBWFR		SPEAKERS 1

VOLUME

2.Turn MULTI JOG until an item you want appears on the display.

•In this example, select “SUBWFR LVL.” For available items, see the list to the left.

	ANALOG
L	R	LINEAR PCM
SUBWFR		SPEAKERS 1

VOLUME

3. Press in MULTI JOG (PUSH SET).

The current setting (or level) for the selected item appears on the display.

	ANALOG
L	R	LINEAR PCM
SUBWFR		SPEAKERS 1

VOLUME

4.Turn MULTI JOG to select a setting you want or to make an adjustment as you like.

	ANALOG
L	R	LINEAR PCM
SUBWFR		SPEAKERS 1

VOLUME

5.Press EXIT.

6.Repeat steps 2 to 5 to set other items if necessary.

7.Press EXIT.

The source indication resumes on the display.

31