Getting Started

English

This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.

Before Installation

General Precautions

•Be sure your hands are dry.

•Turn the power off to all components.

•Read the manuals supplied with the components you are going to connect.

If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.

Notes:

•Supplied batteries are for the initial setup. Replace for continued use.

•After replacing the batteries, set the manufacturers’ codes again (see pages from 47 to 49).

Locations

•Install the receiver in a location that is level and protected from moisture.

•The temperature around the receiver must be between –5˚C and 35˚C (23˚F and 95˚F ).

•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.

Handling the receiver

•Do not insert any metal object into the receiver.

•Do not disassemble the receiver or remove screws, covers, or cabinet.

•Do not expose the receiver to rain or moisture.

CAUTION:

Follow these precautions to avoid leaking or cracking cells:

•Place batteries in the remote control so they match the polarity:

(+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

Connecting the FM and AM Antennas

FM Antenna Connections

Checking the Supplied Accessories

Check to be sure you have all of the following items, which are supplied with the receiver.

The number in the parentheses indicates quantity of the pieces supplied.

•Remote Control (1)

•Batteries (2)

•AM Loop Antenna (1)

•FM Antenna (1)

If anything is missing, contact your dealer immediately.

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries

first.
1	2	3
	R6P(SUM-3)/
	AA(15F)

	ANTENNA	ANTENNA
	A	B
	75	75
	FM	FM
	COAXIAL	COAXIAL
	ANTENNA
		FM Antenna (supplied)
	AM	Extend the supplied FM antenna
	EXT	Extend the supplied FM antenna
	EXT	horizontally.
	AM	horizontally.
	LOOP

FM 75

Outdoor FM Antenna Cable

COAXIAL

(not supplied)

A.Using the Supplied FM Antenna

The FM antenna provided can be connected to the FM 75 Ω

COAXIAL terminal as temporary measure.

1.Press and slide the battery cover on the back of the remote control.

2.Insert the batteries.

• Make sure to match the polarity: (+) to (+) and (–) to (–).

3.Replace the cover.

B.Using the Standard Type Connector (Not Supplied)

A standard type connector should be connected to the FM 75 Ω COAXIAL terminal.

Note:

If reception is poor, connect the outdoor FM antenna (not supplied). Before attaching a 75 Ω coaxial cable with a connector (the kind with a round wire going to an outdoor antenna), disconnect the supplied FM antenna.