JVC RX-8030VBK manual AM Antenna Connections, RX-7030VBK For Front Speakers 2 terminals

AM Antenna Connections

Turn the loop until you have the best reception.

Basic connecting procedure

1 Twist and remove the insulation at the end of each speaker signal cable (not supplied).

2 Open the speaker terminal.

English

ANTENNA

AM

EXT

AM LOOP

FM 75

COAXIAL

AM Loop Antenna (supplied)

Snap the tabs on the loop into the slots of the base to assemble the AM loop.

+ –

LEFT

RIGHT

RX-7030VBK

(For FRONT SPEAKERS 2 terminals)

3 Insert the speaker signal cable.

1 2 3

+ –

LEFT

RIGHT

4 Close the speaker terminal.

Outdoor single vinyl-covered wire (not supplied)

Notes:

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as illustrated.

• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire (not supplied) to the AM EXT terminal. (Keep the AM loop antenna connected.)

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of surround speakers to enjoy the surround effect.

•One surround back speaker or one pair of surround back speakers to enjoy to produce more effective surround effect.

•One center speaker to emphasize human voices.

•One subwoofer to enhance the bass.

CAUTION:

Use only the speakers of the SPEAKER IMPEDANCE indicated by the speaker terminals.

•When connecting to both of the FRONT SPEAKERS 1 and 2 terminals, use speakers with an impedance of 16 Ω to 32 Ω.

•When connecting to either the FRONT SPEAKERS 1 or 2 terminals, use speakers with an impedance of 8 Ω to 16 Ω.

+ –

LEFT

RIGHT

For each speaker (except for a subwoofer), connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

Speaker layout

Ideal speaker layout varies depending on the conditions of your listening room. The diagram below is a recommended typical example.

Subwoofer

Left front speaker(s)	Center speaker	Right front speaker(s)
(L)	(C)	(R)

Left surround	Right surround
speaker (LS)	speaker (RS)

Surround back speakers (LSB/RSB)

9