JVC RX-7030VBK manual RX-8030VBK Left front speaker, Center speaker

Enhancing your audio system	RX-8030V
—Only for RX-8030VBK		ONLY

You can use this receiver as the pre-amplifier (control amplifier) when you connect power amplifiers to the PREOUT jacks on the rear using cables with RCA pin plugs (not supplied).

•Connect the white plug to the audio left jack, and the red plug to the audio right jack.

RX-8030VBK

Left front speaker Right front speaker

Power amplifier

Connecting Audio/Video Components

When connecting individual components, refer also to the manuals supplied with them.

Analog Connections

If your audio components have digital audio output terminal, connecting them using the digital cords explained in “Digital Connections” (see page 16) will give you better sound quality.

Audio component connections

Use the cables with RCA pin plugs (not supplied).

•Connect the white plug to the audio left jack, and the red plug to the audio right jack.

If your audio components have a COMPU LINK jack

See also page 41 for detailed information about the connection and the COMPU LINK remote control system.

CAUTION:

If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

RX-8030V

English

Power amplifier

Turntable

ONLY

		Center speaker
	PREOUT		FRONT
SURR BACK	SURR	CENTER
L			L
			R	L

R R

SUBWOOFER

R L

Power amplifier

To listen to the sound after connection, press PHONO.

RX-8030VBK R

	PHONO
L	IN
	RIGHT	LEFT

Turntable

If a ground cable is

provided for your turntable,

connect the cable to the

screw marked (H) on the

rear.

To audio output

Left surround

speaker

Note:

Power amplifier	Right surround
	speaker

Surround back speakers

Left / Right

Note:

This connection is for the turntable with an MM (moving-magnet) type cartridge.

Any turntables incorporating a small-output cartridge such as an MC (moving-coil) type must be connected to this receiver through a commercial head amplifier or step-up transformer. Direct connection may result in insufficient volume.

If you connect one surround back speaker, connect the surround back speaker to the left surround back PREOUT jack (SURR BACK L).

11