Basic Operations, S.Wfr Lfe Ls S Rs, L C R | JVC RX-6018VBK instruction

Basic Operations

The following operations are commonly used when you play any sound source.

Turning the Power On and Off (Standby)

On the front panel:

	To turn on the power, press POWER.	STANDBY
	To turn on the power, press POWER.
	The STANDBY lamp goes off. The name of	POWER
	the current source (or station frequency)	POWER
	the current source (or station frequency)
	appears on the display.

Selected source name appears

DIGITAL AUTO	SPK		INPUT ATT	SLEEP
ANALOG	L	C	R PROLOGIC DSP H.PHONE AUTOMUTING TUNED STEREO	VOLUME
LINEAR PCM	S.WFR LFE
DIGITAL	LS	S	RS

CH-

Current source name appears

SPK

ANALOG

VOLUME

Current volume level is shown here

DVD	Select the DVD player.
TV SOUND	Select the TV sound.
VCR	Select the video component connected to the
	VCR jacks.
CD *	Select the CD player.
TAPE/CDR *	Select the cassette deck (or the CD recorder).
FM/AM *	Select an FM or AM broadcast.

To turn off the power (into standby mode),

press POWER again.

The STANDBY lamp lights up. A small amount of power is consumed in standby mode. To turn the power off completely, unplug the AC power cord.

From the remote control:

To turn on the power, press AUDIO in the

POWER section.

The STANDBY lamp goes off. The name of the current source (or station frequency) appears on the display.

To turn off the power (into standby mode),

press AUDIO in the POWER section again. The STANDBY lamp lights up.

STANDBY

POWER

AUDIO

• Each time you press the button, the band

alternates between FM and AM.

Notes:

•When connecting a CD recorder (to the TAPE/CDR jacks), change the source name that appears on the display. See page 11 for details.

•When you have connected some digital source components using the digital terminals (see page 7), you need to select the digital input mode.

•When you press one of the source selecting buttons on the remote control marked above with an asterisk (*), the receiver automatically turns on.

Signal and speaker indicators on the display

The signal indicators light up in the following cases:

•Only the indicators for the incoming signals light up.

•When analog input is selected, “L” and “R” always light up.

Selecting the Source to Play	The speaker indicators light up only —:
	• When the corresponding speaker is activated.
	• When the corresponding speaker is activated.

Press one of the source selecting buttons.

On the front panel:

AND

•When the corresponding speaker is required for the DSP mode selected currently.

DVD	VCR	TV SOUND
CD	TAPE/CDR	FM/AM
CD	TAPE/CDR	FM/AM

	SOURCE NAME

From the remote control:

Signal indicators light up in red:

L C R

S.WFR LFE

LS S RS

Speaker indicators light up in white:

L C R

S.WFR LFE

LS S RS

DVD	TV SOUND	VCR
CD	TAPE/CDR	FM/AM

L: • When digital input is selected: Lights up when the left

channel signal comes in.

•When analog input is selected: Always lights up.

R: • When digital input is selected: Lights up when the right

channel signal comes in.

•When analog input is selected: Always lights up.

C:Lights up when the center channel signal comes in. LS: Lights up when the left rear channel signal comes in. RS: Lights up when the right rear channel signal comes in.

S:Lights up when the monaural rear channel signal comes in. LFE: Lights up when the LFE channel signal comes in.

Note:

When “SUBWOOFER” is set to “YES” (see page 11), S.WFR lights up.