JVC RX-6018VBK manual FM tuner IHF, AM tuner, General

Page 33

FM tuner (IHF)

Tuning Range:

Usable Sensitivity:

50 dB Quieting Sensitivity:

Signal-to-Noise Ratio (IHF-A weighted):

Total Harmonic Distortion:

Stereo Separation at REC OUT:

Alternate Channel Selectivity:

Frequency Response:

AM tuner

Tuning Range:

Usable Sensitivity:

Signal-to-Noise Ratio:

General

Power Requirements:

Power Consumption:

Dimensions (W x H x D):

Mass:

87.5 MHz to 108.0 MHz

 

Monaural:

12.8 dBf (1.2 µV/75

Ω)

Monaural:

21.3 dBf (3.2 µV/75

Ω)

Stereo:

41.3 dBf (31.5 µV/75

Ω)

Monaural:

78 dB at 85 dBf

 

Stereo:

73 dB at 85 dBf

 

Monaural:

0.4% at 1 kHz

 

Stereo:

0.6% at 1 kHz

 

35 dB at 1 kHz

45 dB: (±400 kHz)

30 Hz to 15 kHz: (+0.5 dB, –3 dB)

530 kHz to 1 710 kHz

Loop antenna

400 µV/m

 

50 dB (100 mV/m)

AC 120V FM tuner (IHF), 60 Hz

180 W/230 VA (at operation)

2 W (in standby mode)

435 mm x 146.5 mm x 416 mm (17 3/16 in. x 5 13/16 in. x 16 7/16 in.)

8.6 kg (19.0 lbs)

Designs & specifications are subject to change without notice.

30

Image 33
Contents RX-6010VBK / RX-6018VBK POWERAUDIO/VIDEO CONTROL RECEIVER INSTRUCTIONSAttention --Commutateur POWER Caution --POWER switchWarnings, Cautions and Others WARNING TO REDUCE THE RISK OF FIREFor Canada/pour le Canada For Canada/pour Le CanadaFor U.S.A Caution Proper VentilationBasic Settings Table of ContentsUsing the DSP Modes COMPU LINK Remote Control SystemRemote Control Parts Identificationq w e r t y 1 2 3 4 5 6 7 8 9 pChecking the Supplied Accessories Before InstallationConnecting the FM and AM Antennas Getting StartedBasic connecting procedure Connecting the SpeakersConnecting the front speakers Connecting the rear and center speakersConnecting the subwoofer speaker Connecting Audio/Video ComponentsPowered subwoofer Audio component connectionsDVD player Video component connectionsTo audio outputPutting Batteries in the Remote Control Connecting the Power CordDigital connections CAUTIONSBasic Operations Turning the Power On and Off StandbyS.WFR LFE LS S RS From the remote controlMuting the Sound Listening Only with HeadphonesAdjusting the Volume From the remote controlAdjusting the Subwoofer Output Level Adjusting the ToneAttenuating the Input Signal Setting the Subwoofer Information Basic SettingsAdjusting the Front Speaker Output Balance Recording a Source1. Press SETTING repeatedly until Setting the Speakers for the DSP Modes1. Press SETTING repeatedly until Digital Input DIGITAL IN Terminal Setting Selecting the Analog or Digital Input Mode1. Press SETTING repeatedly until Using the Sleep Timer Storing the Basic Settings and AdjustmentsFrom the remote control ONLY From the remote controlTuning in Stations Manually Using Preset TuningReceiving Radio Broadcasts From the remote control To tune in a preset stationSelecting the FM Reception Mode On the front panelWhat are the DSP Modes? Using the DSP ModesSurround modes Dolby Surround Dolby Digital and Dolby Pro LogicReproducing the Sound Field DAP modesAvailable DSP modes according to the input mode By pressing DSP MODE Available DSP modesBy pressing SURROUND MODE To activate the Surround5.Adjust the speaker output levels Adjusting the Surround Modesrepeatedly until “THEATER” 1. Press SURROUND MODEappears on the display JVC Theater Surround adjustmentson the display Adjusting the DAP Modes1. Press SURROUND ON/OFF Activating the DSP ModesCOMPU LINK Remote Control System Automatic Source SelectionSynchronized Recording Operating Audio Components Operating JVC’s Audio/Video ComponentsTuner Sound control section AmplifierCD changer Operating Video ComponentsCassette deck CD recorderPROBLEM TroubleshootingSOLUTION POSSIBLE CAUSE100 W per channel, min. RMS, driven into 8 Ω Specifications40 Hz to 20 kHz with no more than 0.8% total harmonic distortionFM tuner IHF AM tunerGeneral HOW TO LOCATE YOUR JVC SERVICE CENTER JVC SERVICE & ENGINEERING COMPANY OF AMERICAQUALITYSERVICE FACTORY SERVICE CENTER LOCATIONSLIMITED WARRANTY AUDIO-2 VICTOR COMPANY OF JAPAN, LIMITED 0101NHMMDWJEIN