Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 11).
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
•When the front speakers are deactivated, the subwoofer level cannot be adjusted.
On the front panel:
1. Press ADJUST repeatedly until | ADJUST SETTIN |
| |
“SUBWFR LEVEL” appears on |
|
the display. |
|
The display changes to show the current setting.
SPK
ANALOG L R
S.WFR
2. Press CONTROL UP 5/DOWN ° CONTROL
DOWN UP
to adjust the subwoofer output level (+10 dB to
SPK
ANALOG L R
S.WFR
| SPK |
| INPUT ATT |
ANALOG | L | R | H.PHONE |
|
|
|
|
SPK
ANALOG | L | R | H.PHONE |
Notes:
•This function is available only for the sources connected using the analog terminals.
•This function does not take effect when digital input is selected.
Adjusting the Tone
You can adjust the treble and bass sounds as you like.
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until | ADJUST SETTIN |
| |
“BASS” or “TREBLE” appears on |
|
the display. |
|
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound adjustments.
2.Press SUBWOOFER +/– to adjust the subwoofer output level (+10 dB to
SOUND
– SUBWOOFER +
2 3
•Select “BASS” to adjust the bass sound level.
•Select “TREBLE” to adjust the treble sound level.
SPK
ANALOG L R
or
SPK
ANALOG L R
Attenuating the Input Signal
When the input level of the playing source is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.
Once it has been adjusted, the receiver memorizes the adjustment.
On the front panel ONLY:
Press and hold INPUT ATT so that | INPUT ANALOG | |
| ||
the INPUT ATT indicator lights up | INPUT ATT | |
on the display. | ||
|
•Each time you press and hold the button, the Input Attenuator mode turns on (“INPUT ATT ON”) or off (“INPUT NORMAL”).
2.Press CONTROL UP 5/DOWN ° to adjust the bass or treble sound level (+10 dB to
•Each time you press the button, the sound level changes by ± 2 steps.
CONTROL
DOWN UP
10