JVC RX-6018VBK Specifications, W per channel, min. RMS, driven into 8 Ω, harmonic distortion

Page 32
Specifications

Amplifier100 W per channel, min. RMS, driven into 8 Ω, Specifications

Amplifier

Output Power

 

 

 

 

At Stereo operation:

 

 

 

Front channels:

100 W per channel, min. RMS, driven into 8 Ω,

 

 

40 Hz to 20 kHz with no more than 0.8% total

 

 

harmonic distortion.

 

At Surround operation:

 

 

 

Front channels:

100 W per channel, min. RMS, driven into 8 Ω at 1 kHz with no

 

 

more than 0.8% total harmonic distortion.

 

Center channel:

100 W, min. RMS, driven into 8 Ω at 1 kHz, with no more than

 

 

0.8% total harmonic distortion.

 

Rear channels:

100 W per channel, min. RMS, driven into 8 Ω at 1 kHz, with no

 

 

more than 0.8% total harmonic distortion.

Audio

 

 

 

Audio Input Sensitivity/Impedance (1 kHz):

CD, TAPE/CDR, TV SOUND, VCR, DVD:

 

 

 

 

220 mV/47 k Ω

Audio Input (DIGITAL IN)* :

Coaxial: DIGITAL 1 (DVD):

0.5 V (p-p)/75 Ω

 

Optical: DIGITAL 2 (CD):

–21 dBm to –15 dBm (660 nm ±30 nm)

*Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz).

Audio Output Level:

TAPE/CDR, VCR:

 

220 mV

Signal-to-Noise Ratio (’66 IHF/’78 IHF):

CD, TAPE/CDR, TV SOUND, VCR, DVD:

87 dB/67 dB

Frequency Response (8 Ω):

CD, TAPE/CDR, TV SOUND, VCR, DVD:

20 Hz to 20 kHz (±1 dB)

Tone Control:

Bass (100 Hz):

±10 dB

 

 

Treble (10 kHz):

±10 dB

 

Video

Video Input Sensitivity/Impedance:

 

 

Composite video:

VCR, DVD:

1 V (p-p)/75 Ω

Video Output Level:

 

 

Composite video:

VCR, MONITOR OUT:

1 V (p-p)/75 Ω

Synchronization:

Negative

 

Signal-to-Noise Ratio:

45 dB

 

29

Page 31 Page 33
Image 32
Page 31 Page 33
Contents POWER RX-6010VBK / RX-6018VBKAUDIO/VIDEO CONTROL RECEIVER INSTRUCTIONSCaution --POWER switch Attention --Commutateur POWERWarnings, Cautions and Others WARNING TO REDUCE THE RISK OF FIREFor Canada/pour Le Canada For Canada/pour le CanadaFor U.S.A Caution Proper VentilationTable of Contents Basic SettingsUsing the DSP Modes COMPU LINK Remote Control SystemParts Identification Remote Controlq w e r t y 1 2 3 4 5 6 7 8 9 pBefore Installation Checking the Supplied AccessoriesConnecting the FM and AM Antennas Getting StartedConnecting the Speakers Basic connecting procedureConnecting the front speakers Connecting the rear and center speakersConnecting Audio/Video Components Connecting the subwoofer speakerPowered subwoofer Audio component connectionsVideo component connections DVD playerTo audio outputConnecting the Power Cord Putting Batteries in the Remote ControlDigital connections CAUTIONSTurning the Power On and Off Standby Basic OperationsS.WFR LFE LS S RS From the remote controlListening Only with Headphones Muting the SoundAdjusting the Volume From the remote controlAttenuating the Input Signal Adjusting the Subwoofer Output LevelAdjusting the Tone Basic Settings Setting the Subwoofer InformationAdjusting the Front Speaker Output Balance Recording a SourceSetting the Speakers for the DSP Modes 1. Press SETTING repeatedly until1. Press SETTING repeatedly until 1. Press SETTING repeatedly until Digital Input DIGITAL IN Terminal SettingSelecting the Analog or Digital Input Mode Storing the Basic Settings and Adjustments Using the Sleep TimerFrom the remote control ONLY From the remote controlReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning To tune in a preset station From the remote controlSelecting the FM Reception Mode On the front panelUsing the DSP Modes What are the DSP Modes?Surround modes Dolby Surround Dolby Digital and Dolby Pro LogicAvailable DSP modes according to the input mode Reproducing the Sound FieldDAP modes Available DSP modes By pressing DSP MODEBy pressing SURROUND MODE To activate the SurroundAdjusting the Surround Modes 5.Adjust the speaker output levels1. Press SURROUND MODE repeatedly until “THEATER”appears on the display JVC Theater Surround adjustmentsAdjusting the DAP Modes on the displayActivating the DSP Modes 1. Press SURROUND ON/OFFSynchronized Recording COMPU LINK Remote Control SystemAutomatic Source Selection Operating JVC’s Audio/Video Components Operating Audio ComponentsTuner Sound control section AmplifierOperating Video Components CD changerCassette deck CD recorderTroubleshooting PROBLEMSOLUTION POSSIBLE CAUSESpecifications 100 W per channel, min. RMS, driven into 8 Ω40 Hz to 20 kHz with no more than 0.8% total harmonic distortionGeneral FM tuner IHFAM tuner JVC SERVICE & ENGINEERING COMPANY OF AMERICA HOW TO LOCATE YOUR JVC SERVICE CENTERQUALITYSERVICE FACTORY SERVICE CENTER LOCATIONSLIMITED WARRANTY AUDIO-2 0101NHMMDWJEIN VICTOR COMPANY OF JAPAN, LIMITED
Top Page Image Contents