JVC RX-6018VBK manual Warnings, Cautions and Others, Warning To Reduce The Risk Of Fire

Page 2
Warnings, Cautions and Others/

Warnings, Cautions and Others/

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK.

 

DO NOT REMOVE COVER (OR BACK)

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE

OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

Caution –– POWER switch!

Disconnect the mains plug to shut the power off completely. The POWER switch in any position does not disconnect the mains line. The power can be remote controlled.

Attention –– Commutateur POWER!

Déconnecter la fiche de secteur pour couper complètement le courant. Le commutateur POWER ne coupe jamais complètement la ligne de secteur, quelle que soit sa position. Le courant peut être télécommandé.

Image 2
Contents AUDIO/VIDEO CONTROL RECEIVER POWERRX-6010VBK / RX-6018VBK INSTRUCTIONSWarnings, Cautions and Others Caution --POWER switchAttention --Commutateur POWER WARNING TO REDUCE THE RISK OF FIREFor U.S.A For Canada/pour Le CanadaFor Canada/pour le Canada Caution Proper VentilationUsing the DSP Modes Table of ContentsBasic Settings COMPU LINK Remote Control Systemq w e r t y Parts IdentificationRemote Control 1 2 3 4 5 6 7 8 9 pConnecting the FM and AM Antennas Before InstallationChecking the Supplied Accessories Getting StartedConnecting the front speakers Connecting the SpeakersBasic connecting procedure Connecting the rear and center speakersPowered subwoofer Connecting Audio/Video ComponentsConnecting the subwoofer speaker Audio component connectionsTo audio Video component connectionsDVD player outputDigital connections Connecting the Power CordPutting Batteries in the Remote Control CAUTIONSS.WFR LFE LS S RS Turning the Power On and Off StandbyBasic Operations From the remote controlAdjusting the Volume Listening Only with HeadphonesMuting the Sound From the remote controlAttenuating the Input Signal Adjusting the Subwoofer Output LevelAdjusting the Tone Adjusting the Front Speaker Output Balance Basic SettingsSetting the Subwoofer Information Recording a SourceSetting the Speakers for the DSP Modes 1. Press SETTING repeatedly until1. Press SETTING repeatedly until 1. Press SETTING repeatedly until Digital Input DIGITAL IN Terminal SettingSelecting the Analog or Digital Input Mode From the remote control ONLY Storing the Basic Settings and AdjustmentsUsing the Sleep Timer From the remote controlReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning Selecting the FM Reception Mode To tune in a preset stationFrom the remote control On the front panelSurround modes Using the DSP ModesWhat are the DSP Modes? Dolby Surround Dolby Digital and Dolby Pro LogicAvailable DSP modes according to the input mode Reproducing the Sound FieldDAP modes By pressing SURROUND MODE Available DSP modesBy pressing DSP MODE To activate the SurroundAdjusting the Surround Modes 5.Adjust the speaker output levelsappears on the display 1. Press SURROUND MODErepeatedly until “THEATER” JVC Theater Surround adjustmentsAdjusting the DAP Modes on the displayActivating the DSP Modes 1. Press SURROUND ON/OFFSynchronized Recording COMPU LINK Remote Control SystemAutomatic Source Selection Tuner Operating JVC’s Audio/Video ComponentsOperating Audio Components Sound control section AmplifierCassette deck Operating Video ComponentsCD changer CD recorderSOLUTION TroubleshootingPROBLEM POSSIBLE CAUSE40 Hz to 20 kHz with no more than 0.8% total Specifications100 W per channel, min. RMS, driven into 8 Ω harmonic distortionGeneral FM tuner IHFAM tuner QUALITYSERVICE JVC SERVICE & ENGINEERING COMPANY OF AMERICAHOW TO LOCATE YOUR JVC SERVICE CENTER FACTORY SERVICE CENTER LOCATIONSLIMITED WARRANTY AUDIO-2 0101NHMMDWJEIN VICTOR COMPANY OF JAPAN, LIMITED