JVC RX-558VBK manual

Page 2

Warnings, Cautions and Others

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK.

 

DO NOT REMOVE COVER (OR BACK)

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

Caution –– POWER switch!

Disconnect the mains plug to shut the power off completely. The POWER switch in any position does not disconnect the mains line. The power can be remote controlled.

WARNING: TO REDUCE THE RISK OF FIRE

OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN OR MOISTURE.

Caution: Proper Ventilation

To avoide risk of electric shock and fire and to protect from damage.

Locate the apparatus as follows:

Front:

No obstructions open spacing.

Sides:

No obstructions in 10 cm from the sides.

Top:

No obstructions in 10 cm from the top.

Back:

No obstructions in 15 cm from the back

Bottom:

No obstructions, place on the level surface.

In addition, maintain the best possible air circulation as illustrated.

Wall or obstructions

Spacing 15 cm or more

Front

RX-558VBK

Stand height 15 cm or more

Floor

G-1

Image 2
Contents RX-558VBK RX-558VBK Table of Contents Front Panel Remote ControlParts Identification To use the Cursor control buttons q on the front panelChecking the Supplied Accessories Before InstallationConnecting the FM and AM Antennas Setting the Voltage Selector SwitchConnecting the front speakers Connecting the SpeakersAM Antenna ConnectionsBasic connecting procedure Connecting the rear and center speakersAudio component connections Connecting Audio/Video ComponentsConnecting the subwoofer speaker If your audio components have a Compu LINK-3 terminalVideo component connections VCRPlug the power cord into an AC outlet Connecting the Power CordPutting Batteries in the Remote Control + to + and toBasic Operations Turning the Power On and Off StandbyFrom the remote control On the front panelRecording a Source Muting the SoundSelecting the Front Speakers Adjusting the Tone Attenuating the Input SignalAdjusting the Front Speaker Output Balance Reinforcing the BassSetting Center and Rear Speakers for DSP Modes Changing the Source NameUsing the Sleep Timer Storing the Basic Settings Adjustments One Touch OperationAdjust the sound using the functions listed to the left Press ONE Touch OperationReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning Press FM/AM Selecting the FM Reception ModePress the 10 keys to select a preset channel number Press FMDAP modes Using the DSP Modes3D-PHONIC modes Surround ModesAvailable DSP Modes According to the Speaker Arrangement Speaker arrangements Available DSP modesAdjusting the 3D-PHONIC Modes Adjusting the DAP Modes Output balance Press Rearl / + to adjustPress Test to check the speaker Rear speaker output levelActivating the DSP Modes Press DVD Multi Using the DVD Multi Playback ModeActivating the DVD Multi Playback Mode Same time Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Automatic Source SelectionCD player Operating JVC’s Audio/Video ComponentsSound control section Amplifier TunerDVD player Cassette deckMD recorder Troubleshooting Problem Possible Cause SolutionFM tuner IHF SpecificationsAmplifier AM tunerHOW to Locate Your JVC Service Center Limited Warranty AUDIO-2 1298HIMMDWJEM