From the remote control:
SOUND
1. Press SOUND CONTROL. | CONTROL |
|
3. Press TEST to check the speaker | TEST |
output balance. | 2 5 |
The 10 keys are activated for sound adjustments.
2.Press SURROUND repeatedly until the DAP mode — DANCE CLUB, LIVE CLUB, HALL, or PAVILION — appears on the display.
SURROUND
3
“TEST ” starts flashing on the display, and a | |
test tone comes out of the speakers in the | |
following order: |
|
Left front speaker | Center speaker |
Rear speaker | Right front speaker |
The DAP indicator also lights up on the display.
3. Press REAR•L | – REAR•L + | |||||||
rear speaker output level. | 8 5 |
|
|
|
|
|
| 9 |
|
|
|
|
|
| |||
Note:
You can adjust the speaker output levels without outputting the test tone.
•Pressing REAR•L – decreases the output level up to
•Pressing REAR•L + increases the output level up to +10 dB.
Note:
You cannot adjust the left and right rear speaker output levels
separately.
4.Press CENTER
5.Press REAR•L
– CENTER +
5 | 6 | 5 |
– REAR•L + |
| |
8 5
9
4. Press EFFECT to select an effect | EFFECT | |||||
level you want. | 4 |
| ||||
• Each time you press the button, the effect |
|
| ||||
level changes as follows: |
|
| ||||
EFFECT 1 |
| EFFECT 2 |
| EFFECT 3 |
| |
|
|
| ||||
Notes:
•You cannot adjust the left and right rear speaker output levels separately.
•You cannot use the REAR•R
EFFECT 5 | EFFECT 4 |
As the number increases, the selected DAP mode becomes stronger.
Adjusting the Surround Modes — Dolby
Surround and JVC Theater Surround
Before you start, remember...
6.Press TEST again to stop the test tone.
7.ONLY FOR JVC Theater Surround:
Press EFFECT to select an effect level you want.
•Each time you press the button, the effect level changes as follows:
TEST
25
EFFECT
4
•Make sure that you have set the speaker information correctly (see page 11).
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
•You can only adjust the effect level when selecting JVC Theater Surround.
•You can only adjust the rear and/or center speaker output levels when you have connected rear speakers and/or a center speaker and have set “REAR SPK” and/or “CNTR SPK” correctly. See page 11.
From the remote control:
EFFECT 1 
EFFECT 2 
EFFECT 3
EFFECT 5 | EFFECT 4 |
As the number increases, JVC Theater Surround becomes stronger.
1. Press SOUND CONTROL.
The 10 keys are activated for sound adjustments.
2.Press SURROUND repeatedly until the mode — “PROLOGIC” or “3 STEREO” or “THEATER”
SOUND
CONTROL
SURROUND
3
•For “PROLOGIC” and “3 STEREO,” the PRO LOGIC indicator lights up on the display.
•For “THEATER,” the PRO LOGIC and DAP indicators light up on the display.
18