JVC RX-558VBK manual Specifications, Amplifier, FM tuner IHF, AM tuner, General

Page 27

Specifications

Amplifier

Output Power

At Stereo operation: 100 watts per channel, min. RMS, driven into 8 ohms, at 40 Hz to 20 kHz with no more than 0.8 % total harmonic distortion.

At Surround operation:

Front Channel:

100 watts per channel, min. RMS, driven into

 

8 ohms at 1 kHz with no more than 0.8 % total

 

harmonic distortion.

Center channel:

100 watts, min. RMS, driven into

 

8 ohms at 1 kHz, with no more than 0.8 %

 

total harmonic distortion.

Rear channel:

50 watts per channel, min. RMS, driven into 8

 

ohms at 1 kHz, with no more than 0.8 % total

 

harmonic distortion.

Total Harmonic Distortion (8 ohms, 1 kHz):

0.8 %* at 100 watts output

(* Measured by JVC Audio Analysis System)

Audio

Audio Input Sensitivity/Impedance (1 kHz): PHONO (MM): 2.7 mV/47 k ohms CD, TAPE/MD, VCR, DVD:

220 mV/47 k ohms

Audio Output Level: TAPE/MD, VCR 220 mV

Signal-to-Noise Ratio (’66 IHF/’78 IHF):

PHONO:70 dB/77 dB (at REC OUT)

CD, TAPE/MD, VCR, DVD:

87 dB/67 dB

Frequency Response (8 ohms):

PHONO:20 Hz to 20 kHz (±1 dB) CD, TAPE/MD, VCR, DVD:

20 Hz to 20 kHz (±1 dB)

RIAA Phono Equalization: ±1.0 dB (20 Hz to 20 kHz)

Video

Video Input Sensitivity/Impedance:

VCR, DVD:

1Vp-p/75 phms

Video Output Level:

VCR, MONITOR OUT: 1Vp-p/75 ohms

Synchronization:Negative

Signal-to-Noise Ratio: 45dB

FM tuner (IHF)

Tuning Range:

87.5 MHz to 108.0 MHz

Usable Sensitivity: Monaural: 17.0 dBf (1.95 µV/75 ohms)

50 dB Quieting Sensitivity:

Monaural:

21.3 dBf (3.2 µV/75 ohms)

Stereo:

41.3 dBf (31.5 µV/75 ohms)

Signal-to-Noise Ratio (IHF-A weighted):

Monaural:

78 dB at 85 dBf

Stereo:

73 dB at 85 dBf

Total Harmonic Distortion:

Monaural:

0.4 % at 1 kHz

Stereo:

0.6 % at 1 kHz

Stereo Separation at REC OUT: 35 dB at 1 kHz

Alternate Channel Selectivity:

45 dB: (±400 kHz)

Frequency Response:30 Hz to 15 kHz: (+0.5 dB, –3 dB)

AM tuner

 

 

 

Tuning Range:

530 kHz to 1,710 kHz

Usable Sensitivity: Loop antenna

400 µV/m

Signal-to-Noise Ratio:

 

50 dB (100 mV/m)

General

 

 

 

Power Requirements:

 

AC 120V

, 60 Hz

Power Consumption:

 

290 watts/390 VA (at operation)

 

 

2 watts (in standby mode)

Dimensions (W x H x D):

435 x 146 x 403.5 mm

 

 

(17 3/16 x 5 3/4 x 15 15/16 inches)

Mass:

 

10.2 kg (22.5 lbs)

Designs & specifications are subject to change without notice.

25

Image 27
Contents RX-558VBK RX-558VBK Table of Contents To use the Cursor control buttons q on the front panel Remote ControlParts Identification Front PanelSetting the Voltage Selector Switch Before InstallationConnecting the FM and AM Antennas Checking the Supplied AccessoriesConnecting the rear and center speakers Connecting the SpeakersAM Antenna ConnectionsBasic connecting procedure Connecting the front speakersIf your audio components have a Compu LINK-3 terminal Connecting Audio/Video ComponentsConnecting the subwoofer speaker Audio component connectionsVCR Video component connections+ to + and to Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletOn the front panel Turning the Power On and Off StandbyFrom the remote control Basic OperationsMuting the Sound Selecting the Front SpeakersRecording a Source Reinforcing the Bass Attenuating the Input SignalAdjusting the Front Speaker Output Balance Adjusting the ToneChanging the Source Name Setting Center and Rear Speakers for DSP ModesPress ONE Touch Operation Storing the Basic Settings Adjustments One Touch OperationAdjust the sound using the functions listed to the left Using the Sleep TimerTuning in Stations Manually Using Preset TuningReceiving Radio Broadcasts Press FM Selecting the FM Reception ModePress the 10 keys to select a preset channel number Press FM/AMSurround Modes Using the DSP Modes3D-PHONIC modes DAP modesSpeaker arrangements Available DSP modes Available DSP Modes According to the Speaker ArrangementAdjusting the 3D-PHONIC Modes Adjusting the DAP Modes Rear speaker output level Press Rearl / + to adjustPress Test to check the speaker Output balanceActivating the DSP Modes Using the DVD Multi Playback Mode Activating the DVD Multi Playback ModePress DVD Multi Automatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Same timeTuner Operating JVC’s Audio/Video ComponentsSound control section Amplifier CD playerCassette deck MD recorderDVD player Problem Possible Cause Solution TroubleshootingAM tuner SpecificationsAmplifier FM tuner IHFHOW to Locate Your JVC Service Center Limited Warranty AUDIO-2 1298HIMMDWJEM