JVC RX-558VBK manual Activating the DSP Modes

DOLBY SURROUND

DOLBY SURROUND

On the front panel:

You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.

8. ONLY FOR JVC Theater

Surround:

Press cursor control @/ #to

select an effect level you want.

• Each time you press the button, the effect

1. Press SURROUND repeatedly until the mode — “PROLOGIC” or

SURROUND

level changes as follows:

“3 STEREO” or “THEATER”—appears on the display.

The PRO LOGIC indicator lights up on the display.

2. Press ADJUST so that the cursor	ADJUST
control %/ Þ/ @/ #buttons work
for adjusting the DSP setting.

3. Press cursor control % / Þ repeatedly until “–CENTER+” appears on the display.

4.Press cursor control @/ #to adjust the center speaker output

level (from –10 to +10).

5.Press cursor control % / Þ repeatedly until “– REAR +”

appears on the display.

6.Press cursor control @/ #to adjust the rear speaker output

level (from –10 to +10).

Note:

EFFECT 1 EFFECT 2 EFFECT 3

EFFECT 5 EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

Activating the DSP Modes

Once you have finished adjustments for the DSP modes, you can use the same adjustments every time you want to use these modes.

On the front panel:

SURROUND

1. Press SURROUND repeatedly until the DSP mode you want appears on the display.

•Each time you press the button, the DSP modes change. (See page 16 for more details)

2.Select and play a sound source.

•To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with

Dolby Surround and is labeled with mark.

To cancel the DSP mode

Press SURROUND repeatedly until “OFF” appears on the display.

From the remote control:

1. Press SOUND CONTROL.	SOUND
	CONTROL

The 10 keys are activated for sound adjustments.

2. Press SURROUND repeatedly

You cannot adjust the left and right rear speaker output levels

until the DSP mode you want

SURROUND

separately.

appears on the display.

3

7.ONLY FOR JVC Theater Surround:

Press cursor control % / Þ repeatedly until “–EFFECT+” appears on the display.

•Each time you press the button, the DSP modes change. (See page 16 for more details)

3.Select and play a sound source.

•To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with

Dolby Surround and is labeled with mark.

To cancel the DSP mode

Press SURROUND repeatedly until “OFF” appears on the display in step 2 above.

19