English
AM Antenna ConnectionsBasic connecting procedure
| Snap the tabs on the loop into the | 1 | 2 | 3 |
ANTENNA |
|
|
| |
slots of the base to assemble the |
|
|
| |
FM 75 |
|
|
| |
AM loop. |
|
|
| |
COAXIAL |
|
|
| |
|
|
|
|
AM
LOOP
AM
EXT AM Loop Antenna
123
Outdoor single
Turn the loop until you have the best reception.
Note:
•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.
•If reception is poor, connect an outdoor single
Connecting the Speakers
You can connect the following speakers:
•Two pairs of front speakers to produce normal stereo sound.
•One pair of rear speakers to enjoy the surround effect.
•One center speaker to produce more effective surround effect (to emphasize human voices).
•One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP (Digital Signal Processor ) effect. For details, see page 11.
For each speaker (except for a subwoofer), connect the
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
1Cut, twist and remove the insulation at the end of each speaker signal cable.
2Open the terminal and then insert the speaker signal cable.
3Close the terminal.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).
Right speaker |
| FRONT SPEAKERS 1 |
| Left speaker |
|
|
FRONT SPEAKERS
RIGHTLEFT
1 | 1 |
2 | 2 |
Right speaker |
| FRONT SPEAKERS 2 |
| Left speaker |
|
|
Connecting the rear and center speakers
Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.
Center speaker | CENTER | RIGHT | LEFT | |
SPEAKER |
|
| ||
Left rear | Right rear |
|
| REAR |
speaker | speaker |
|
| |
|
| SPEAKERS |
4