ProForm PFTL71730 Pulse/Calories/Fat, Distance/Incline/Laps Display, Speed display -This, Avoid

Pulse/Calories/Fat
Calories	display	—This
display shows the ap-
proximate numbers of
calories	and	fat calories

you have burned (see

FAT BURNING on page 27). The display will change from one number to the other every few seconds. The display will also show your heart rate when you use the handgrip pulse sensor (see

step 6 at the right) or the optional chest pulse sen-
sor (see page 22).
Distance/Incline/Laps
display	—This display
shows the distance that
you have walked, the in-
cline level of the tread-
mill, and the number of

1/4-mile laps you have completed. The display will change from one number to the next every few seconds. Note: Each time the incline changes, the display will show the current incline setting for sev- eral seconds.

Speed display —This

display shows the speed of the walking belt.

Note: When the Km/H in-
dicator is lit, the console
will display speed and
distance in kilometers;
when the Km/H indicator
is not lit, the console will
display speed and distance in mile	s. To change
the unit of measurement, first hold down the Stop
button while inserting the key into the console. An

“E” for English miles or an “M” for metric kilometers will appear in the Speed display. Press the Speed

+button to change the unit of measurement. When the desired unit of measurement is selected, re- move the key and then reinsert it.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

6 Measure your heart rate if desired.

You can measure your heart rate using either the handgrip pulse sensor or the optional chest pulse sensor.

	To use the
	handgrip pulse
	sensor, first		Contacts
	make sure that
	your hands are
	clean. Next,
	stand on the
	foot rails and
	place your
	hands on the metal contacts on the handgrip
	pulse sensor. Your palms should be resting on the
	upper contacts, and your fingertips should be
	touching the lower contacts.		Avoid	moving your
	hands	. When your pulse is detected, tw		o dashes
	(– –) will appear in the Pulse/Calories/Fat Calories
	display, and then your heart rate will be shown.
	For the most accurate heart rate reading, con-
	tinue to hold the contacts for about 15 sec-
	onds.
7	Turn on the fans if desired.

To use the fans, press the Low or High button. To turn off the fans, press the Off button. Note: Any time that the walking belt is stopped for a few min- utes, the fans will automatically turn off.

When you are finished exercising, remove the

8 key from the console.

Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage posi-

tion or the treadmill will be damaged.Next, re- move the key from the console and put it in a se-

cure place. Note: If the displays and various indi- cators on the console remain lit after the key is removed, the console is in the “demo” mode.

See page 22 and turn off the demo mode.

When you are finished using the treadmill, move the reset/off circuit breaker near the power cord to the off position and unplug the power cord.

12