If heart rate program

Current Segment

Column

Press the Start button or the Speed increase

6 button to start the program.

A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings of the program. Hold the handrails and begin walking.

Heart rate program 7 is divided into several one- minute segments. The same target heart rate set- ting is programmed for all segments. (For a shorter workout, simply stop the program before it ends.) Heart rate program 8 is divided into 30 one-minute segments. One target heart rate set- ting is programmed for each segment. Note: The same target heart rate setting may be pro- grammed for two or more consecutive segments.

8 is selected, the target heart rate setting for the first segment will

be shown in the flash- ing Current Segment column of the matrix. The target heart rate settings for the next

several segments will be shown in the columns to the right. When only three seconds remain in the first segment of the program, both the Current Segment column and the column to the right will flash and a series of tones will sound.

When the first segment ends, all target heart rate settings will move one column to the left. The tar- get heart rate setting for the second segment will then be shown in the flashing Current Segment column.

During both heart rate programs, the console will regularly compare your heart rate to the target heart rate setting for the current segment. If your

heart rate is too far below or above the target heart rate setting, the speed of the walking belt will automatically increase or decrease to bring your heart rate closer to the target heart rate set- ting.

If the speed or incline setting is too high or too low at any time during the program, you can adjust the setting with the Speed or Incline buttons. However, when the console compares your heart rate to the target heart rate setting, the speed of the treadmill may automatically change to bring your heart rate closer to the target heart rate setting.

If your pulse is not detected during the program, the letters “PLS” will flash in the right display and the speed of the treadmill may automatically de- crease. If this occurs, see CHEST PULSE SEN- SOR TROUBLESHOOTING on page 8.

To stop the program at any time, press the Stop button. To restart the program, press the Start but- ton or the Speed increase button. The walking belt will begin to move at 1 mph. When the console compares your heart rate to the target heart rate setting, the speed and/or incline of the treadmill may automatically change to bring your heart rate closer to the target heart rate setting.

7 Follow your progress with the displays.

See step 5 on page 11.

8 Turn on the fan if desired.

See step 7 on page 12.

When you are finished exercising, remove the

9 key from the console.

See step 7 on page 14.