PART | R0106A |
To locate the parts listed below, see the EXPLODED DRAWING attached in the center of this manual.
Key No. | Qty. | Description | Key No. | Qty. | Description |
1 | 2 | Foot Rail | 51 | 1 | Key/Clip |
2 | 1 | Hood Cover | 52 | 4 | Rear Foot Star Washer |
3 | 1 | Pulse Receiver | 53 | 2 | Rear Roller Adjustment Bolt |
4 | 4 | Isolator | 54 | 1 | Left Rear Endcap |
5 | 1 | Latch Housing Cover | 55 | 1 | Frame |
6 | 1 | Platform | 56 | 1 | Allen Wrench |
7 | 4 | Walking Platform Screw | 57 | 2 | Rear Platform Screw |
8 | 1 | Walking Belt | 58 | 1 | Rear Roller |
9 | 2 | Frame Pivot Bolt | 59 | 1 | Access Door |
10 | 4 | Frame Pivot Washer | 60 | 1 | Chest Pulse Strap |
11 | 1 | Front Wheel/Pulley | 61 | 1 | Pulse Bar |
12 | 1 | Magnet | 62 | 4 | Pulse Bar Screw |
13 | 7 | Front Roller Nut/Front Wheel Nut | 63 | 1 | Idler Arm |
14 | 2 | Spacer Insert | 64 | 1 | Idler Spring |
15 | 2 | Frame Pivot Spacer | 65 | 1 | Upright/Base |
16 | 1 | Reed Switch Clip | 66 | 4 | Belt Guide Screw |
17 | 1 | Reed Switch | 67 | 1 | Console Frame |
18 | 1 | Lift Frame | 68 | 1 | Latch Housing |
19 | 2 | Foot Rail Insert | 69 | 2 | Console Washer |
20 | 4 | Foot Screw | 70 | 4 | Console Bolt |
21 | 14 | Foot Rail Screw | 71 | 1 | Console Wire Harness |
22 | 1 | Motor Belt | 72 | 1 | iFIT.com Wire |
23 | 2 | 1/2” Tek Screw | 73 | 2 | Incline Pivot Bolt/Wheel Bolt |
24 | 1 | Drive Motor | 74 | 1 | Flywheel |
25 | 1 | Book Holder | 75 | 2 | 1/2” Screw |
26 | 1 | Left Handgrip, Bottom | 76 | 1 | Motor Isolator Plate |
27 | 4 | Hood Bracket | 77 | 2 | Front Wheel |
28 | 1 | Ground Wire | 78 | 4 | Isolator Screw |
29 | 2 | Star Washer | 79 | 1 | Pulley Nut |
30 | 1 | Right Rear Endcap | 80 | 1 | Console |
31 | 1 | Lift Motor Bolt | 81 | 1 | Console Base |
32 | 2 | Motor Bolt | 82 | 1 | Console Fan |
33 | 1 | Chest Pulse Sensor | 83 | 1 | Controller Star Washer |
34 | 1 | Left Handgrip, Top | 84 | 6 | Belly Pan Screw |
35 | 1 | Right Handgrip, Top | 85 | 1 | Upright Wire Harness |
36 | 1 | Right Handgrip, Bottom | 86 | 1 | Shock |
37 | 1 | Controller | 87 | 2 | Spring Plate Spacer |
38 | 1 | Controller Bracket | 88 | 2 | Upright Endcap |
39 | 1 | Motor Hood | 89 | 1 | Filter Wire |
40 | 56 | 3/4” Screw | 90 | 1 | Latch Warning Decal |
41 | 1 | Motor Belly Pan | 91 | 1 | Incline Motor |
42 | 2 | Belt Guide | 92 | 1 | Motor Controller Wire |
43 | 8 | 3/4” Tek Screw | 93 | 8 | Fan Screw |
44 | 20 | Electronics Screw | 94 | 2 | |
45 | 1 | Left Front Endcap | 95 | 2 | Tie Holder |
46 | 1 | Right Front Endcap | 96 | 1 | Tie |
47 | 1 | Ground Screw | 97 | 5 | 8” Cable Tie |
48 | 2 | Rear Foot | 98 | 2 | Base Pad |
49 | 1 | Console Ground Wire | 99 | 1 | Idler Arm Bolt |
50 | 2 | Wheel Housing | 100 | 1 | Idler Arm Nylon Washer |
26