HOW to USE a Preset Program

Current Segment

Column

1 Insert the key into the console.

See HOW TO TURN ON THE POWER on page 10.

2 Select a preset program.

To select a preset program, press the Speed & Incline Programs button repeatedly. The right dis- play will show which program (P-1 to P-6) is se- lected.

When a preset program is selected, the left dis- play will flash the maximum incline setting of the program for a few seconds, and the right display will flash the maximum speed setting. The left dis- play will then show how long the program will last. In addition, a profile of the speed settings of the program will scroll across the matrix in the left dis- play.

Matrix

Press the Start button or the Speed increase

3 button to start the program.

A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings of the program. Hold the handrails and begin walking.

Each program is divided into several one-minute segments. One speed setting and one incline set- ting are programmed for each segment. Note: The same speed setting and/or incline setting may be programmed for two or more consecutive seg- ments.

The speed setting for the first segment will be shown in the flashing Current Segment column

of the matrix. (The in- cline settings are not shown in the matrix.) The speed settings for the next seven segments

will be shown in the columns at the right.

When only three seconds remain in the first seg- ment of the program, both the Current Segment column and the column to the right will flash, and a series of tones will sound. If the speed and/or in- cline of the treadmill is about to change, the left display and/or the right display will flash to alert you. When the first segment ends, all speed set- tings in the matrix will move one column to the left. The speed setting for the second segment will then be shown in the flashing Current Segment column, and the treadmill will automatically adjust to the speed and incline settings for the second segment. Note: If all of the indicators in the Current Segment column are lit after the speed settings have moved to the left, the speed settings may move downward so that only the highest indi- cators appear in the matrix. If some indicators in the Current Segment column are not lit when the speed settings move to the left again, the speed settings will move back up.

The program will continue in this way until the speed setting for the last segment is shown in the Current Segment column and the last segment ends. The walking belt will then slow to a stop.

If the speed or incline setting is too high or too low at any time during the program, you can manually override the setting by pressing the Speed or Incline buttons. Every few times a Speed button is pressed, an additional indicator will appear or dis- appear in the Current Segment column. (If any of the columns to the right of the Current Segment column have the same number of indicators as the Current Segment column, an additional indicator may appear or disappear in those columns as well.) Note: When the next segment of the pro- gram begins, the treadmill will automatically adjust to the speed and incline settings for the next segment.