ProForm 831.293062 user manual Troubleshooting, Solution, Power Cord

Page 22

TROUBLESHOOTING

Most treadmill problems can be solved by following the simple steps below. Find the symptom that

applies, and follow the steps listed. If further assistance is needed, call toll-free 1-800-4-MY-HOME® (1-800-469-4663).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c.Check the on/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the on/off circuit breaker has tripped. To reset the on/off circuit breaker, wait for five minutes and then press the switch back in.

c

Tripped

Reset

PROBLEM: The power turns off during use

SOLUTION: a. Check the on/off circuit breaker (see the drawing above). If the on/off circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key fully into the console.

 

d. If the treadmill still will not run, please call toll-free 1-800-4-MY-HOME

® (1-800-469-4663).

PROBLEM: The incline of the treadmill does not change correctly

 

SOLUTION:

a. With the key in the console, press one of the Incline buttons.

While the incline is changing, re-

 

move the key.

After a few seconds, re-insert the key. The treadmill will automatically rise to the

 

maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The console is too high or too low

SOLUTION: a. See assembly step 7 on page 7.

PROBLEM: The treadmill rocks during use

SOLUTION: a. See HOW TO LEVEL THE TREADMILL on page 20.

PROBLEM: The displays of the console do not function properly

SOLUTION:

a. Remove the key from the console and

UNPLUG THE

 

POWER CORD.

With the help of a second person,

carefully tip the Upright Base (97) down as shown. Remove the five Hood Screws (44). Note: A phillips screwdriver with at least a 5” shaft is required.

a

44

44

44

 

97

 

44

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model No Serial No Serial Number DecalTable of Contents Important PrecautionsNever insert any object into any opening Move the Treadmill onDecals shown have been placed on your treadmill. If a Before YOU Begin Using the treadmillBack Make sure that the power cord is unplugged AssemblyPart is missing, call toll-free May be preattached to the Left Upright Wires on the sides of the Console BaseUprights 80, 84 as shown Wire Loosen the Upright Bolts two to three turns107 Make sure that no wires are pinched.ReattachTreadmill on CylinderThis product must be grounded.If it should malfunc HOW to Plug in the Power CordPerformant Lube Grounded Outlet BoxFeatures of the Console Settes, call toll-freeHOW to USE the Manual Mode Distance/Incline dis Calories/PulseDisplay AvoidPress the Start button or the Speed HOW to USE Preset ProgramsSelect one of the preset programs Start the programFollow your progress with the displays From the console When the program has endedPut it in a safe place Turn on the fans if desired Enter your age and a maximum speed settingFrom the console HOW to Connect Your Portable Stereo HOW to Connect Your Portable CD PlayerCassettes Plug the adapter into the Line OUT jack on your stereo HOW to Connect Your Home StereoHOW to Connect Your Computer Plug the adapter into an RCA Y-adapter availablePrograms HOW to Connect Your VCRVCR Make sure that the audio cable is properly Next settings of the CD or video programStart button or the Speed button on the console See onHOW to USE Programs Directly from OUR WEB Site HOW to Level the Treadmill Information MODE/DEMO ModeOptional Chest Pulse Sensor HOW to Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Lower the Treadmill for USE Solution TroubleshootingPower Cord If the walking belt is off-center Problem The walking belt slows when walked onUnplug Power Cord Belt has shifted to the leftWorkout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Washer Description Key No. QtyMotor Pulley Qty101 Console Base 120 Right Top Handgrip 102 Optic Disk 121 Part Identification ChartKey No. Qty Description 107 Console 126Exploded R0803A Sears, Roebuck and Co., Dept WA, Hoffman Estates, IL Full ONE Year WarrantyPart No R0803A
Top Page Image Contents