ProForm 831.293062 May be preattached to the Left Upright, Incorrect, Are, 111, 109, 101, Pulse

3. Attach the Latch Assembly (82) to the Left Upright (84)						3
	with the two Latch Screws (46). Start both Latch Screws
	before tightening either of them. Note: The Latch Screws
	may be preattached to the Left Upright.
							46	82
							84
4. Refer to step 6 and locate the four Upright Bolts (86).						4a		4b
	Loosen the Upright Bolts two to three turns.
	Refer to drawing 4c. With the help of a second person,
	hold the Console Base (101) near the Uprights (80, 84).
	Look under the Console Base and locate the wires on
	the sides of the Console Base. Make sure that the wires						Correct	Incorrect
	are	not	routed through the openings for the Trays (109,
	111). Drawing 4a shows the correct route for the wires.					4c
	Drawing 4b shows an incorrect route.
	Refer to drawing 4c. Cut the plastic ties holding the Wire						111
	Harness (74) and the Pulse Wire in the Uprights (80, 84).							109
	Connect the Wire Harness and the Pulse Wire to the
	wires on the sides of the Console Base (101).			Make sure
	to connect the connectors properly (see the inset						101	81
	drawings). IF THE CONNECTORS ARE NOT CON-
							75
	NECTED PROPERLY, THE CONSOLE MAY BE DAM-
	AGED WHEN THE POWER IS TURNED ON. The con-						80
	nectors should slide together easily and snap into							84
	place.		If the connectors do not slide together easily and
	snap into place, turn one connector and try again. Insert
	the excess Wire Harness and Pulse Wire up into the
	Console Base.
	Press the Right and Left Top Endcaps (75, 81) into the						74	Pulse
	Uprights (80, 84) as shown.							Wire
5.	Set the Console Base (101) on the Uprights (80, 84).				Be	5		101
	careful not to pinch the Wires (not shown) in the
	Uprights.		Attach the Console Base to each Upright with					84
	two Console Bolts (76) and two Internal Star Washers
	(77); start all four Console Bolts before tightening any of						111	109
	them.
	Make sure that the Left and Right Trays (109, 111) are
	pressed into the Console Base (101).							77
							77
								77
						76	80	76
					6