ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver 
(not included).
1.Note: One person must hold the Console Base (91) near the Upright (71) during steps 1, 2, and 3. If this is not done, the wire harness connecting the con- sole to the treadmill may be permanently damaged.
Hold the Console Base (91) near the Upright (71).
Refer to inset drawing A. Connect the Wire Harness (85) to the Console Wire Harness (121). Connect the 4” Ground Wire (120), the 54” Hand Pulse Wire (95) and the 25” Hand Pulse Wire (83) to the Pulse Wire Harness (77) (make sure that the Wires with tags are connected to each other).
2.Slide the Left and Right Base Mounts (104, 78) onto the plastic pins on the sides of the Console Base (91).
Next, carefully insert the Left and Right Base Mounts (104, 78) into the Upright (71) as shown.
Refer to the inset drawing. Carefully feed all wires into the hole in the Upright (71) as shown. Make sure that the wires are routed through the notch in the base mount and under the plastic pin. Be careful not to pull on the wires or they may become disconnected from the console.
3.Slide the Left and Right Lower Base Mounts (105, 79) onto the Left and Right Base Mounts (104, 78). Attach the Lower Base Mounts with eight 3/4” Screws (77) as shown. Be careful not to overtighten the Screws.
1 |
|
| 91 |
| 71 |
A |
|
85 | 121 |
95 |
|
83 | 77 |
120 |
|
2 |
|
104 | 91 |
78 |
|
| Pin |
|
|
|
| Notch | 71 |
|
|
|
|
| |
71 |
|
|
|
|
3 | 104 |
| 78 |
|
105 |
| 79 | ||
77 |
|
|
| 77 |
5