10.Insert the indicated connectors and tie into the Right Upright (78).
Next, set the Handrail Base (96) onto the Handrail Spacers (97, 98).
Attach the Handrail Base (96) with four 3/8" x 1/2" Bolts (7) and four 3/8" Star Washers (9); start all four Bolts and then tighten them.
Press four (three are shown) Handrail Caps (99) into the ends of the Handrail Base (96).
See steps 5 and 8. Tighten the four 3/8" x 4 1/2" Bolts (6).
11.Pull the end of the Handrail Wire (52) out of the hole in the Handrail Base (96).
With the help of a second person, hold the con- sole assembly near the Handrail Base (96). Connect the Handrail Wire (52) to the console wire. See the lower inset drawing in step 8.
The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Connect the Console Ground Wire (101) to the console assembly ground wire. Insert the wires into the console assembly.
Attach the console assembly with three 3/8" x 3" Bolts (5) and three 3/8" Star Washers (9). Be careful not to pinch the wires.
10 | 99 |
|
|
|
|
|
|
| |
97 |
| 9 | 96 |
|
|
| Connectors | ||
| 9 | 7 |
| 99 |
|
|
| ||
|
|
| 7 | 98 |
| 99 |
| 9 | Tie |
|
|
| 78 |
|
11 | Console |
|
|
|
|
|
|
| |
| Assembly |
|
|
|
|
| Console |
|
| Assembly |
Console | Ground Wire | |
Wire | 52 | 101 |
| 96 | 9 |
| 5 | |
10