ProForm CS user manual HOW to Fold and Move the Treadmill, HOW to Move the Treadmill

Page 20

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the latch knob is locked in the storage position.

1.Hold a handrail and the frame and place one foot against one of the wheels.

2.Tilt the treadmill back until it rolls freely on the wheelsNever. Carefully move the treadmill to the desired location. move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until it is resting in the storage position.

Frame

Latch Knob

Frame

Handrail

Wheel Base

20

Image 20
Contents QUESTIONS? Model No. PFTL79108.0 Serial NoTable of Contents Important Precautions Pulse sensor is not a medical devicePage Before YOU Begin Assembly See the inset drawing. Tie the wire tie Nut the Wheel must turn freely. DiscardCareful not to pinch the Upright Wire Do not fully tighten the Bolts yetNot fully fold the Frame yet Bolt and Nut will be used in the next asView a Console Ground Wire 101 Is oriented as shown and is facing Make sure that no wires are pinchedHold the receiver so the small cylinder PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Start the walking belt and adjust the speedSeconds When you are finished exercising, remove Adjust the incline of the treadmill to the lowestFollow your progress with the display Stand onFollow your progress with the display. See on HOW to USE a Personal Trainer WorkoutSelect a personal trainer workout HOW to USE the Ifit Competition Training Center HOW to USE the Settings Mode Select the settings modeMeasure your heart rate if desired. See on Enter user informationInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Compatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Problem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL79108.0 Key No. Qty Description104 Lift Motor Spacer Userʼs Manual Exploded Drawing A-Model No. PFTL79108.0 R0708A Exploded Drawing B-Model No. PFTL79108.0 R0708A Exploded Drawing C-Model No. PFTL79108.0 R0708A Exploded Drawing D-Model No. PFTL79108.0 R0708A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty