8.With the help of a second person, hold a Bolt Spacer (80) inside the lower end of the Left Upright (74). Insert a 3/8" x 4 1/2" Bolt (6) with a 3/8" Star Washer (9) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (80), 3/8" x 4 1/2" Bolt (6), and 3/8" Star Washer (9).
Orient the Left Upright (74) and the Left Upright Spacer (76) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (83). Partially tighten the two 3/8" x 4 1/2" Bolts (6); do not fully tighten the Bolts yet.
With the help of a second person, tip the tread- mill so that the Base (83) is flat on the floor.
9.See the upper inset drawing. Orient the Right Handrail Spacer (98) with the Right Upright (78) as shown. Insert the Upright Wire (38) and wire tie through the Right Upright Spacer and press the Spacer onto the Upright.
Have a second person hold the Handrail Base (96) near the Right Upright (78).
Connect the Upright Wire (38) to the Handrail Wire (52). See the lower inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connec- tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON- SOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Remove the wire tie from the Upright Wire.
8 | 74 |
6 | |
9 | 76 |
| |
80 | 83 |
|
9 |
| Wire Tie 38 | |
96 | 98 | ||
78 | |||
38 | View A | ||
52 | 98 | View A | |
Wire Tie | 78 | 52 | |
| |||
|
| ||
|
| 38 | |
9