ProForm CS user manual

Page 4



20.	Never leave the treadmill unattended while it		24.	Inspect and properly tighten all parts of the
	is running. Always remove the key, unplug			treadmill regularly.
	cuit breaker to the off position when the		25. DANGER: Always unplug the power
	the power cord, and switch the reset/off cir-			cord immediately after use, before cleaning the
	treadmill is not in use. (See the drawing on
	page 5 for the location of the circuit breaker.)			treadmill, and before performing the mainte-
21.	Do not attempt to raise, lower, or move the			nance and adjustment procedures described in
				this manual. Never remove the motor hood un-
	treadmill until it is properly assembled. (See			less instructed to do so by an authorized ser-
	ASSEMBLY on page 6, and HOW TO FOLD			vice representative. Servicing other than the
	AND MOVE THE TREADMILL on page 20.)			procedures in this manual should be performed
	You must be able to safely lift 45 lbs. (20 kg)			by an authorized service representative only.
22.	to raise, lower, or move the treadmill.		26. This treadmill is intended for in-home use
	When folding or moving the treadmill, make			only. Do not use this treadmill in a commer-
	sure that the storage latch is holding the			cial, rental, or institutional setting.
23.	frame securely in the storage position.
	Never insert any object into any opening on
	the treadmill.	SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. PFTL79108.0 Serial NoTable of Contents Important Precautions Pulse sensor is not a medical devicePage Before YOU Begin Assembly See the inset drawing. Tie the wire tie Nut the Wheel must turn freely. DiscardCareful not to pinch the Upright Wire Do not fully tighten the Bolts yetNot fully fold the Frame yet Bolt and Nut will be used in the next asView a Console Ground Wire 101 Hold the receiver so the small cylinder Make sure that no wires are pinchedIs oriented as shown and is facing HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Start the walking belt and adjust the speedSeconds When you are finished exercising, remove Adjust the incline of the treadmill to the lowestFollow your progress with the display Stand onSelect a personal trainer workout HOW to USE a Personal Trainer WorkoutFollow your progress with the display. See on HOW to USE the Ifit Competition Training Center HOW to USE the Settings Mode Select the settings modeMeasure your heart rate if desired. See on Enter user informationInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL79108.0 Key No. Qty Description104 Lift Motor Spacer Userʼs Manual Exploded Drawing A-Model No. PFTL79108.0 R0708A Exploded Drawing B-Model No. PFTL79108.0 R0708A Exploded Drawing C-Model No. PFTL79108.0 R0708A Exploded Drawing D-Model No. PFTL79108.0 R0708A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT