How to Move the Hiker
Before moving the hiker, change the grade of the hiker to the lowest level and unplug the power cord.
1.Hold the handrails as shown and place one foot against the walking belt.
2.Tilt the hiker back until it rolls freely on the wheels. The help of a second person may be helpful when tipping the hiker. Carefully move the hiker to the desired location.
Never move the hiker without tipping it back. To re- duce the risk of injury, use extreme caution while moving the hiker. Do not attempt to move the hiker over an uneven surface.
3.Place one foot on the walking belt, and carefully lower the hiker until it is resting on the floor.
Wheels |
Trouble-shooting
Most problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c.Check the circuit breaker located on the hiker near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d.Check the on/off switch located on the hiker near the power cord. The switch must be in the on position.
c
Tripped | Reset |
d
On
Position
20