ProForm 1800 Operation and Adjustment, HOW to Connect the Power Cord, Use a Surge Suppressor

Page 16

OPERATION AND ADJUSTMENT

HOW TO CONNECT THE POWER CORD

Use a Surge Suppressor

Your treadmill, like other electronic equipment, can be damaged by sudden voltage changes in your home’s power. Voltage surges, spikes, and noise interfer- ence can result from weather conditions or from other appliances being turned on or off. To decrease the risk of damaging the treadmill, always use a surge suppressor with the treadmill. To purchase a surge suppressor, see precaution 12 on page 3.

Use only a surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must also be electri- cally rated for 120 volts AC and 15 amps. There must be a monitoring light on the surge suppressor to indi- cate whether it is functioning properly. Failure to use a properly functioning surge suppressor could result in damage to the control system of the treadmill and serious injury to users.

Plug in the Power Cord

nominal 120-volt circuit capable of carrying 15 or more amps. To avoid overloading the circuit, do not plug other electrical devices, except for low- power devices such as cell phone chargers, into the surge suppressor or into an outlet on the same circuit. IMPORTANT: The treadmill is not compat- ible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets.

1

Grounded Outlet

Grounding Pin

Grounding Pin

Surge

Suppressor

The treadmill must be grounded. If it should malfunc- tion or break down, grounding provides a path of least resistance for electric current to reduce the risk of elec- tric shock. The treadmill power cord has a plug with a grounding pin (see drawing 1 on this page).

DANGER: Improper connection of the power cord increases the risk of elec- tric shock. Do not modify the plug—if it will not fit an outlet, have a proper outlet installed by a qualified electrician. If you are unsure

Atemporary adapter may be used to connect the surge sup- pressor to a 2-pole receptacle if a properly grounded outlet is not available.

2

2-pole Receptacle

Adapter

Lug

Metal

Screw

whether the treadmill is properly grounded, contact a qualified electrician.

Plug the power cord into a surge suppressor, and plug the surge suppressor into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. The outlet must be on a

The lug or wire extending from the adapter must be connected with a metal screw to a permanent ground such as a properly grounded outlet box cover.

Some 2-pole receptacle outlet box covers are not grounded. Before using an adapter, contact a quali- fied electrician to determine whether the outlet box cover is grounded. The temporary adapter should be used only until a properly grounded outlet can be installed by a qualified electrician.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents QUESTIONS? Model No. PFTL11011.0 Serial NoCall TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedTighten the Screws yet. Note Use the short hex See the inset drawing. Tie the wire tieAttach the Right Upright not shown Base Covers into place yet Page Page Console Assembly Make sure to follow all Instructions in this step Raise the Frame 56 to the position shown Press the Grommet 77 into the square hole in the Base HOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Features of the Console DiagramConsole HOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the Console Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode When you are finished exercising, remove Power cord. Important If you do not doMeasure your heart rate if desired Key from the consoleSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeCalibrate the incline system of the treadmill Find keycodesHOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeMake sure that the audio wire is fully plugged HOW to USE the Stereo Sound SystemHOW to USE the Internet Browser HOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Qty DescriptionDescription Qty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents