ProForm 1800 user manual

Page 4

20.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and press the power switch into the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the power switch.)

21.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 29.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22.When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

23.Never insert any object into any opening on the treadmill.

24.Inspect and properly tighten all parts of the treadmill regularly.

25.DANGER: Always unplug the power cord immediately after use, before clean- ing the treadmill, and before performing the maintenance and adjustment procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized ser- vice representative only.

26.This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial, rental, or institutional setting.

27.Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. PFTL11011.0 Serial NoCall TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedTighten the Screws yet. Note Use the short hex See the inset drawing. Tie the wire tieAttach the Right Upright not shown Base Covers into place yet Page Page Console Assembly Make sure to follow all Instructions in this step Raise the Frame 56 to the position shown Press the Grommet 77 into the square hole in the Base HOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Features of the Console DiagramConsole HOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the Console Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode When you are finished exercising, remove Power cord. Important If you do not doMeasure your heart rate if desired Key from the consoleSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeCalibrate the incline system of the treadmill Find keycodesHOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeMake sure that the audio wire is fully plugged HOW to USE the Stereo Sound SystemHOW to USE the Internet Browser HOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Qty DescriptionDescription Qty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT