ProForm 2 To pinch the Upright Wire, Bolts yet Attach the Left Upright 91 in the same way

2. Identify the Right Upright (92), which is marked	2		Wire
with a “Right” sticker.
Have a second person hold the Right Upright			Tie	93
(92) near the Right Base Cover (102). See the
inset drawing. Tie the wire tie in the lower end		91
of the Right Upright securely around the end of
the Upright Wire (93). Then, pull the other end
of the wire tie in the top of the Right Upright until				92
the Upright Wire is routed through the Right
Upright.
Gently pull up on the Upright Wire (93) as you				102
set the Right Upright (92) on the Base (103) in-
side the Right Base Cover (102). Be careful not				103
to pinch the Upright Wire.
Attach the Right Upright (92) to the Base (103)
with two 3/8" x 3 3/4" Bolts (5) and two 3/8" Star				6
Washers (6). Note: It may be necessary to tip
the top of the Right Upright forward slightly as
you thread the Bolts into it. Do not tighten the	92	93		5
Bolts yet.
Attach the Left Upright (91) in the same way.		Wire
Note: There are no wires on the left side.		Tie

3. With the help of a second person, lower the	3
treadmill off the cardboard stand. The stand will		89
be used again in assembly step 9.	91
Identify the Right Upright Sleeve (90) and the		“Left”	“Right”
Left Upright Sleeve (89), which are labeled				90
“Right” and “Left.”
Slide the Right Upright Sleeve (90) onto the
Right Upright (92), and slide the Left Upright				92
Sleeve (89) onto the Left Upright (91).
			Cardboard
			Stand
	7