Omron HJ-112 instruction manual Battery Installation, Open the Battery Cover Insert the battery

Page 10

Operating Instructions

Battery Installation

1.Remove the Screw on the Battery Cover located on the back of the main unit.

Use the supplied screwdriver or use a commercially available small screwdriver to remove the screw on the battery cover.

2.

3.

Open the Battery Cover.

Insert the battery.

Place the positive (+) side of the battery (CR2032) upward. Insert the battery in the direction of the arrow as illustrated.

4.Replace the Battery Cover.

Insert the projected portion of the battery cover as illustrated.

Tighten the screw on the Battery Cover.

NOTES:

•After installing the battery, set the time of day, weight and stride length.

•Remove the protective film from the face of the display.

10

Image 10

Contents Pocket Pedometer Model HJ-112 Contents Introduction SAVE THESE InstructionsImportant Safety Information Operating the DeviceCare and Maintenance System Reset Button Battery Cover Screw of Battery Cover Know Your UnitHow to attach the strap to the main unit ComponentsCalorie Display Aerobic Step Function300 x 0.95 = 285 kcal How to measure your stride length Stride Length MeasurementOpen the Battery Cover Insert the battery Battery InstallationReplace the Battery Cover Battery Replacement Press the MEMO/ Button to advance by increments of one hour Setting the TimeSetting range 1200 AM-1159 PM Install the battery Press the SET Button to set the hourPress the SET button to set the minute Press the SET Button to set the weight Setting the WeightSetting range 70 to 300 lb Press the MEMO/ Button to advance by increments of 1 lbPress the MEMO/ Button to advance by increments of 1 inch Setting the Stride LengthSetting range 100 to 400 feet Press the SET Button to the stride lengthAttaching the Pedometer Place the unit in your pocketUp and down movement Unit moves irregularlyWalking at an inconsistent pace Vibrations from a moving vehiclePress the Mode Button to change the display Changing the DisplayPress the Mode Button to return to the current day’s data Using the Memory FunctionPress the Memory Button. The previous day data is displayed Use the system reset function in the following cases Using the System Reset FunctionSet the time, weight, and stride length again Care and Maintenance Troubleshooting Tips Problem Cause SolutionSpecifications HJ-112N HJ-113-ZSFCC Statement Limited Warranty Page Page Omron Healthcare, Inc