Omron HJ-112 instruction manual Attaching the Pedometer, Place the unit in your pocket

Page 16

Attaching the Pedometer

The unit may be placed in the upper front pocket of your clothing, in the front pocket of your pants, in a bag, or attached to your belt or pants.

Place the unit in your pocket.

Do not place the unit in the back pocket to prevent sitting on it.

Attach the clip on the edge of your pocket to prevent the unit from dropping.

Place the unit in your bag.

Place or clip the unit in a horizontal or vertical position in a secure section or pocket of your bag.

Attach the unit to your belt or the top of your pants.

Use the supplied holder.

Clip the unit in a horizontal or vertical position on your belt or top your pants, skirt, etc.

NOTE:

The display will show all activity after 4 seconds of movement. All steps taken during those 4 seconds will be included and shown on the display.

16

Image 16

Contents Pocket Pedometer Model HJ-112 Contents Introduction SAVE THESE InstructionsImportant Safety Information Operating the DeviceCare and Maintenance System Reset Button Battery Cover Screw of Battery Cover Know Your UnitHow to attach the strap to the main unit ComponentsCalorie Display Aerobic Step Function300 x 0.95 = 285 kcal How to measure your stride length Stride Length MeasurementOpen the Battery Cover Insert the battery Battery InstallationReplace the Battery Cover Battery Replacement Setting the Time Setting range 1200 AM-1159 PM Install the batteryPress the MEMO/ Button to advance by increments of one hour Press the SET Button to set the hour Press the SET button to set the minute Setting the Weight Setting range 70 to 300 lbPress the SET Button to set the weight Press the MEMO/ Button to advance by increments of 1 lbSetting the Stride Length Setting range 100 to 400 feetPress the MEMO/ Button to advance by increments of 1 inch Press the SET Button to the stride lengthAttaching the Pedometer Place the unit in your pocketUnit moves irregularly Walking at an inconsistent paceUp and down movement Vibrations from a moving vehiclePress the Mode Button to change the display Changing the DisplayPress the Mode Button to return to the current day’s data Using the Memory FunctionPress the Memory Button. The previous day data is displayed Use the system reset function in the following cases Using the System Reset FunctionSet the time, weight, and stride length again Care and Maintenance Troubleshooting Tips Problem Cause SolutionSpecifications HJ-112N HJ-113-ZSFCC Statement Limited Warranty Page Page Omron Healthcare, Inc