Omron HJ-112 instruction manual Setting the Stride Length, Setting range 100 to 400 feet

Page 15

Setting the Stride Length

Setting range: 1'00'' to 4'00'' feet

The stride length flashes on the display.

1. Press the MEMO/▲ Button to advance by increments of 1 inch.

Press and hold the button to advance the stride in 4 inches increments.

NOTE:

Press the MODE Button to return the stride length to 1'08''.

2. Press the SET Button to the stride length.

The number of steps and time will be displayed.

All the settings are completed.

To change the time, weight, or stride length after the setting is completed:

1.Press and hold the SET Button for 2 seconds.

2.Change the setting.

NOTE:

If setting does not need to be changed, press the set button to advance to the next setting.

Image 15

Contents Pocket Pedometer Model HJ-112 Contents SAVE THESE Instructions IntroductionOperating the Device Important Safety InformationCare and Maintenance Know Your Unit System Reset Button Battery Cover Screw of Battery CoverComponents How to attach the strap to the main unitAerobic Step Function Calorie Display300 x 0.95 = 285 kcal Stride Length Measurement How to measure your stride lengthBattery Installation Open the Battery Cover Insert the batteryReplace the Battery Cover Battery Replacement Press the SET Button to set the hour Setting the TimeSetting range 1200 AM-1159 PM Install the battery Press the MEMO/ Button to advance by increments of one hourPress the SET button to set the minute Press the MEMO/ Button to advance by increments of 1 lb Setting the WeightSetting range 70 to 300 lb Press the SET Button to set the weightPress the SET Button to the stride length Setting the Stride LengthSetting range 100 to 400 feet Press the MEMO/ Button to advance by increments of 1 inchPlace the unit in your pocket Attaching the PedometerVibrations from a moving vehicle Unit moves irregularlyWalking at an inconsistent pace Up and down movementChanging the Display Press the Mode Button to change the displayUsing the Memory Function Press the Mode Button to return to the current day’s dataPress the Memory Button. The previous day data is displayed Using the System Reset Function Use the system reset function in the following casesSet the time, weight, and stride length again Care and Maintenance Problem Cause Solution Troubleshooting TipsHJ-112N HJ-113-ZS SpecificationsFCC Statement Limited Warranty Page Page Omron Healthcare, Inc