3.Tip: Be careful not to pinch the Wire Harness (100) during this step. Start all screws before tightening any of them.
Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright. Tie the lower end of the wire tie to the Wire Harness (100). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside the Upright (2), secure the Wire Harness with a rubber band.
Attach the Upright (2) to the Frame (1) with four M10 x 20mm Button Screws (79), and four M10 Split Washers (78). Tip: Tighten the two
Button Screws on the front of the elliptical exerciser before tightening the other two Button Screws.
4.Tip: Be careful not to pinch the Wire Harness (100) during this step.
Orient the Bottle Holder (5) as shown and slide it onto the Upright (2). Attach the Bottle Holder with two M4 x 32mm Screws (95).
Slide the Console Cover (96) onto the Upright
(2)and move it downward to the Bottle Holder. Then, insert the Console Bracket (3) into the top of the Upright. Attach the Console Bracket with four M4 x 16mm Screws (84).
3
Wire Tie
Avoid pinching the
2Wire Harness (100)
during this step
79 | 78 | 78 |
|
|
79
78
100 
179
4
3 
96
100
84
84
2
5
95
7