ProForm 831.23743.0 user manual Tip Be careful not to pinch the wires during this step

5.The Console (4) can be operated with four 1.5V “D” batteries (not included); alkaline batteries are recommended. IMPORTANT: If the elliptical exerciser has been exposed to cold tempera- tures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Remove the two screws from the back of the console, and remove the battery cover. Insert four batteries into the Console. Orient the batteries as shown by the markings inside the battery compartment. Then, reattach the battery cover.

The Console (4) can also be operated with a regulated 6-volt DC 2-amp power supply (not included). To purchase a power supply, call your local Sears store. To avoid damaging the console, use only a manufacturer-sup- plied power supply. Plug one end of the power supply into the jack on the Console; plug the other end into an outlet installed in accordance with all local codes and ordinances.

6.Tip: Be careful not to pinch the wires during this step.

While a second person holds the Console (4) near the Upright (2), connect the console wire to the Wire Harness (100).

Attach the Console (4) with four M4 x 16mm Flat Head Screws (94).

5

Cover

4

Screws

Batteries

6

4

Console Wire

100

2

96

94 94

8