ProForm PFSY74490 user manual Trap is oriented as shown

33.Attach the bolt at the end of the Ab Cable (74) to a “U”-Bracket (97) with a 1/4” Flat Washer (71) and a 1/4” Nylon Locknut (68). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the bolt, as shown in the inset drawing.

Attach the “U”-Bracket (97) to the hole in the Short Weight Tube (17) with a 5/16” x 1 3/4” Bolt (60) and a 5/16” Nylon Locknut (64).

34.Identify the Low Cable (75). It has a ball on one end and a loop on the other. Route the end with the loop through the slot in the cable guide on the Butterfly Base (4).

Route the Low Cable (75) under a 3 1/2” Pulley (24). Attach the Pulley and a Cable Trap (25) to the brack- et on the Butterfly Base (4) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50). Make sure the Cable

Trap is oriented as shown.

35.Wrap the Low Cable (75) around a 3 1/2” Pulley (24). Attach two 3 1/2” Pulleys (24) and two Cable Traps

(25)to the Butterfly Upright (1) with a 3/8” x 5” Bolt

(108)and a hand tightened 3/8” Nylon Locknut (50) as shown. Do not tighten the Nylon Locknut before step 37.

36.Wrap the Low Cable (75) over a 3 1/2” Pulley (24) as shown. Attach the Pulley and a Cable Trap (25) to the lower hole in the second set of Pulley Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).

Make sure the Cable Trap is oriented as shown.

33		64
74
60		97
		71
17
		68
74
71
68
97
34
Bracket
54
4	25	75
		24
		50
Cable Guide

35	1
		75
	25
50
24	25
	24	108
36
	23	50
75	24
		25
54

14