ProForm PFSY74490 user manual Make sure that the Cable Trap is oriented as shown

49.Wrap the High Cable (72) around a 3 1/2” Pulley (24) as shown. Attach the Pulley, a Cable Trap (25), and an Angle Spacer (103) to the 3/8” x 4” Carriage Bolt

(104)in the Press Base (6). Make sure the Angle Spacer is angled exactly as shown. Secure the Pulley with a 3/8” Nylon Jam Nut (63). Make sure the

Cable Trap is oriented as shown.

50.Wrap the High Cable (72) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley inside the indicated bracket on the Weight Base (5) with a 3/8” x 1 3/4” Bolt (57) and a 3/8” Nylon Locknut (50).

Make sure that the Cable Trap is oriented as shown.

51.Wrap the High Cable (72) over a 4 1/2” Pulley (102) in the direction shown. Attach the Pulley inside the indicated bracket on the Weight Top Frame (66) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).

52.Attach the bolt at the end of the High Cable (72) to the remaining “U”-Bracket (97) with a 1/4” Flat Washer (71) and a 1/4” Nylon Locknut (68). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

Attach the “U”-Bracket (97) to the hole in the Long Weight Tube (96) with a 5/16” x 1 3/4” Bolt (60) and a 5/16” Nylon Locknut (64).

Follow all four cables from end to end. Make sure that they rest in the grooves of the pulleys and that the cables and the pulleys move smoothly.

49
		63
		24
		25
		72
		103
	6
50
		24
	Bracket
		57
		72
	50
	5
51
66	50	102
	Bracket	54
		72
52
	72
	97	64
72	60	71
71
		68
		96
68
97

18