ProForm PFSY74490 user manual Trouble-shooting and Maintenance, Adjusting the Press Plate

Adjusting the Press Plate

Remove the Lock Pin (22) from the Press Plate (55) and the Press Front Leg (20).

Align the holes in the Press Plate (55) with the desired set of holes in the Press Front Leg (20). Re-insert the Lock Pin (22) through the Press Front Leg and the Press Plate.

22

55

20

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

Tightening the Cables	A
Woven cable, the type of cable used on the weight sys-
tem, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables		7
should be tightened. Slack can be removed from the			24
cables in several different ways:
A. Move the indicated 3 1/2” Pulley (24) to another set
of holes in the bracket on the Press Upright (2).
Moving the Pulley closer to the Press Upright will			2
tighten the cables. Moving it further away from the
Upright will loosen the cable.
B. Remove the 3 1/2” Pulley (24) and the Cable Trap	B
(25) from a set of Pulley Plates (23). Re-attach the
Pulley and the Cable Trap to the inner hole in the
Pulley Plates with the 3/8” x 2” Bolt (54) and the 3/8”
Nylon Locknut (50). Note: If the Cable is still too
loose after moving a Pulley, repeat the process
with another Pulley.
	23		Adjustment
			holes
	54		50
			25
			24

25