ProForm PFSY74490 user manual

C. The bolt on the Ab Cable (74) and the High Cable	C
(72) that are attached to the weight stacks can also
be used to tighten the cables.
Remove the “U”-Bracket (97) from the Short Weight		74	72
Tube (17). Tighten the 1/4” Nylon Locknut (68) onto	Bolt	64
the bolt on the end of the Ab Cable (74) two turns.
Re-attach the “U”-Bracket (97) with the 5/16” x 1 3/4”	97
Bolt (60) and the 5/16” Nylon Locknut (64).
The High Cable (72) can be tightened in the same	60	71
manner.		68
Note: The shrouds are shown removed for clarity.		17
The shrouds do not need to be removed to tight-
en the cables.
Note: If a cable tends to slip off the pulleys often,
the cable may have become twisted. Remove the
cable and re-install it.
If the cables need to be replaced, see Ordering
Replacement Parts on the back cover of this manual.

26