ProForm PFSY74490 Nylon Locknuts yet, Tighten all of the Nylon Locknuts 64 used in this step

14.Press a 2” Square Inner Cap (28) into the Butterfly Front Leg (3). Slide the Butterfly Front Leg onto the indicated 5/16” x 2 1/2” Carriage Bolts (92) in the Butterfly Base (4). Hand tighten two 5/16” Nylon Locknuts (64) onto the Bolts. Do not tighten the

Nylon Locknuts yet.

Attach the Butterfly Front Leg (3) to the Butterfly Seat Frame (14) with two 5/16” x 2 3/4” Bolts (89), two 5/16” Washers (36), and two 5/16” Nylon Locknuts (64). Tighten all of the Nylon Locknuts used in steps 13 and 14.

15.Press a 2” Square Inner Cap (28) into the Press Seat Frame (7).

Slide the Press Seat Frame (7) onto the indicated 5/16” x 2 1/2” Carriage Bolts (92) in the Press Base

(6). Hand tighten two 5/16” Nylon Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet.

Attach the Press Seat Frame (7) to the Press Upright

(2)with two 5/16” x 2 3/4” Bolts (89), two 5/16” Washers (36), and two 5/16” Nylon Locknuts (64).

Tighten all of the Nylon Locknuts (64) used in this step.

16.Press two 2” Square Inner Caps (28) into the ends of the Leg Lever (41). Attach the Bumper (40) to the Butterfly Front Leg (3) with a 1” Tap Screw (80).

Lubricate the 3/8” x 3 1/4” Bolt (62). Attach the Leg Lever (41) to the Butterfly Front Leg (3) with the Bolt and a 3/8” Nylon Jam Nut (63). Do not overtighten the Nylon Jam Nut; the Leg Lever must pivot freely.

17.Press a 2” x 3” Inner Cap (98) into the indicated end of the Press Front Leg (20).

Orient the Press Front Leg (20) with the welded rod in the position shown. Attach the Press Front Leg to the Press Base (6) with a 1/2” x 3 1/2” Bolt (105) and a 1/2” Nylon Jam Nut (106). Do not overtighten the

Nylon Jam Nut; the Press Front Leg must pivot freely.

14	28
	36	64	14
89
	3		64
		64
			4
			92
15	89		36
			64
			36
			2
28	7
	89
	64
			6
	92
16
28	63
41			62
	80	3
28	40
17	98
	Welded
	Rod
	20
	106		6
			105

9