5.Identify the Left Handlebar (9), which is marked with a sticker. Insert the Left Handlebar into one of the Handlebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the indicated side. Attach the Left Handlebar to the Handlebar Leg with two M8 x 43mm Button Bolts (50) and two M8 Nylon Locknuts (46). Make sure that the
Nylon Locknuts are seated in the hexagonal holes. Do not fully tighten the Button Bolts yet.
Attach the Right Handlebar (not shown) to the other Handlebar Leg (not shown) in the same way.
6.Apply a generous amount of the included grease to the Pivot Axle (108) and to the two M8.5 Small Washers (53). Insert the Pivot Axle into the Upright (2) and center it. Reapply grease to both sides of the Pivot Axle.
Identify the Left and Right Handlebars (9, 10), which are marked with stickers. Slide a Handlebar Spacer
(25)onto the short tube on each Handlebar, and slide the Handlebars onto the Pivot Axle (108). Make sure that the Handlebars are on the correct sides.
Orient the two Handlebar Caps (23) as shown, and press the small tabs on the Handlebar Caps into the two Handlebar Spacers (25). Tighten an M8 x 19mm Shoulder Screw (22) with an M8.5 Small Washer (53) into each end of the Pivot Axle (108).
7.Apply a thin film of grease to the shaft of a Union Bolt Set (27) and to the two Bushings (28) in the left Handlebar Leg (79).
Attach the left Handlebar Leg (79) to the left Flex Bar (14) with the Union Bolt Set (27).
See assembly step 5 above. Tighten the two M8 x 43mm Button Bolts (50) in the left Handlebar Leg (79).
Make sure that the M8 Nylon Locknuts (46) are seated in the hexagonal holes.
Repeat this step to attach the right Handlebar Leg (79) to the right Flex Bar (14).
5 |
|
|
9 |
|
|
| Tube |
|
| 46 |
|
50 | Hexagonal | |
79 | Holes |
|
|
| |
6 |
|
|
|
| 22 |
| 10 | 23 53 |
|
| 108 |
9 | Tube |
|
| Grease | |
|
| |
Tube |
|
|
53 23 | 25 |
|
22 |
|
|
25 |
|
|
Grease |
|
|
2 |
|
|
7 |
|
|
79 | 79 |
|
|
| |
28 | 27 | 14 |
| ||
|
| |
Grease |
|
|
14 |
|
|
27 |
|
|
7