11. Identify the Left Pedal (13) and the Left Pedal | 11 |
|
|
|
Leg (14), which are marked with “Left” stickers, |
|
|
| |
|
|
|
| |
and orient them as shown. |
|
| 13 |
|
|
|
|
| |
Attach the Left Pedal (13) to the Left Pedal |
|
|
|
|
Leg (14) with four M6 x 35mm Phillips |
|
|
|
|
Screws (87) and four M6 Split Washers (88). |
|
|
|
|
Start all four Phillips Screws before tighten- |
|
|
|
|
ing any of them. |
| 14 |
|
|
|
|
|
| |
Repeat this step to attach the Right Pedal to |
|
|
|
|
the Right Pedal Leg (not shown). |
|
|
|
|
|
|
| 88 | 88 |
|
|
| 87 | 87 |
|
|
|
| |
12. Apply a generous amount of grease to two Pedal | 12 | 11 |
| |
Leg Axles (32). Insert one Pedal Leg Axle into |
| |||
|
| |||
the lower end of the Left Handlebar Leg (11). |
| Grease | 32 |
|
Insert the other Pedal Leg Axle into the Left |
|
| ||
Roller Leg (12). |
| 98 |
|
|
|
|
|
|
Apply a small amount of grease to both sides of | 12 |
|
two Wave Washers (98). Slide a Wave Washer | Grease | 32 |
onto each Pedal Leg Axle (32). |
| |
|
|
98
13. Orient the Left Pedal Leg (14) as shown, and | 13 |
|
|
|
|
slide it onto the Pedal Leg Axles (32). Attach the | 11 |
|
|
| |
|
|
|
| ||
Left Pedal Leg to the Left Handlebar Leg (11) |
|
|
|
|
|
with two M10 x 20mm Patch Screws (91), two |
| 32 |
|
|
|
Axle Caps (31), and two M10 x 25mm |
| 31 |
| 94 | |
|
|
| |||
Washers (94). |
| 94 |
| 91 | 91 |
|
|
| 12 | ||
Attach the Left Pedal Leg (14) to the Left Roller |
|
|
| ||
|
|
|
| 32 | |
Leg (12) with two M10 x 20mm Patch |
|
|
|
| |
Screws (91) and two M10 x 25mm Washers (94); |
|
|
|
|
|
do not overtighten the Patch Screws. The |
|
|
|
|
|
Legs (11, 14, 12) must pivot freely. | 31 |
|
|
|
|
|
|
|
|
| |
Repeat step 12 and this step for the Right |
| 94 |
|
|
|
Pedal Leg (not shown). | 91 |
| 14 |
|
|
|
|
|
| ||
|
|
|
|
| |
|
|
|
| 91 | 94 |
|
|
|
|
| |
| 10 |
|
|
|
|