ProForm PFEL79907.1 Maintenance and Troubleshooting, Handgrip Pulse Sensor Troubleshooting

Page 23

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Make sure to regularly clean the rollers and the track on which the rollers ride. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.

HANDGRIP PULSE SENSOR TROUBLESHOOTING

If the console does not display your heart rate when you hold the handgrip pulse sensor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 16.

HOW TO LEVEL THE ELLIPTICAL EXERCISER

If the elliptical exerciser rocks slightly on your floor during use, see HOW TO LEVEL THE ELLIPTICAL EXERCISER on page 13.

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first remove the screws from the left and right side shields (not shown). Note: There are two

different sizes of screws in the side shields; be sure to note the location of each screw. Then, gently pull the side shields apart and remove the convenience tray.

Next, locate the Idler Screw (68) and loosen it one half turn. Step onto the elliptical exerciser and move the pedals. If the pedals continue to slip, turn the Idler Screw another half turn and test the pedals again. Continue in this way until the pedals no longer slip. Then, replace the convenience tray and reattach the side shields.

68

23

Image 23
Contents Call TOLL-FREE QUESTIONS?Model No. PFEL79907.1 Serial No Table of Contents Important Precautions Before YOU Begin Assembly Page Avoid pinching Wires and cable during this step Locknuts are inside the hexagonal holes Repeat this step for the Right Handlebar Repeat this step for the Right Handlebar not shownRepeat and this step for the Right Pedal Leg not shown Do not overtighten the Patch Screws.This step WiresAvoid pinching HOW to Connect a 75 OHM Catv Cable HOW to Level the Elliptical Exerciser HOW to USE the Elliptical ExerciserHOW to Plug in the Power Cord HOW to Move the Elliptical ExerciserFeatures of the Console Console DiagramFollow your progress with the display HOW to USE the Manual ModeSelect the manual mode Change the resistance of the pedals as desiredIf the pedals do not move for several seconds, a When you are finished exercising, the consoleWill turn off automatically Select a preset program HOW to USE a Preset ProgramHold the handgrip pulse sensor HOW to USE a Heart Rate ProgramSelect a heart rate program Select a custom program HOW to Create a Custom ProgramChange the program if desired HOW to USE a Custom ProgramPress the Volume buttons to adjust the volume HOW to Operate the Personal TelevisionHOW to Operate a DVD Player or VCR Select the appropriate viewing modePress the TV button again and select a cable connection HOW to USE the Information ModePress the TV button again and add or delete cable channels HOW to Adjust the Drive Belt Maintenance and TroubleshootingHandgrip Pulse Sensor Troubleshooting Solution Television TroubleshootingProblem Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Page Key No. Qty Description Part LIST-Model No. PFEL79907.1Qty Description PFEL79907.1 Exploded Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty